Database Administration Manual - IP7 Secure
Gateway
When this command has successfully completed, this message should appear.
rlghncxa03w 10-07-07 08:41:12 GMT
Link set table is (20 of 1024) 2% full.
CHG-LS: MASP A - COMPLTD
5. Any in-service IP connections on the signaling link being removed in this procedure must be placed
out of service.
Have the far-end node for the signaling link being removed place the M3UA or SUA associations
in either the ASP-INACTIVE or ASP-DOWN state.
6. Display the IP link associated with the card that the signaling link being removed the database is
assigned to. Enter the rtrv-ip-lnk command with the card location of the signaling link being
removed shown in
rtrv-ip-lnk:loc=2207
The following is an example of the possible output.
rlghncxa03w 06-10-28 21:14:37 GMT EAGLE5 36.0.0
LOC
PORT IPADDR
2207
A
192.1.1.10
2207
B
--------------- --------------- HALF
7. Display the IP host information associated with the IP link by entering the rtrv-ip-host command
with the IP address shown in
rtrv-ip-host:ipaddr=192.001.001.010
The following is an example of the possible output.
rlghncxa03w 08-12-28 21:17:37 GMT EAGLE5 40.0.0
LOCAL IPADDR
192.1.1.10
IP Host table is (11 of 2048) 1% full
8. Display the associations associated with the local host name shown in
rtrv-assoc command. For this example, enter this command.
rtrv-assoc:lhost=ipnode1_2207
This is an example of possible output.
rlghncxa03w 06-10-28 09:12:36 GMT EAGLE5 36.0.0
ANAME
assoc1
IP Appl Sock/Assoc table is (4 of 4000) 1% full
Assoc Buffer Space Used (16 KB of 3200 KB) on LOC = 2207
9. Change the value of the open and alw parameters to no by specifying the chg-assoc command
with the open=no and alw=no parameters, as necessary. For this example, enter this command.
Note: If there is no association shown in
association shown in
910-6278-001 Revision A, January 2012
Step
1. For this example, enter this command.
SUBMASK
255.255.255.128 HALF
Step
6. For this example, enter these commands.
LOCAL HOST
IPNODE1_2207
CARD IPLNK
LOC
PORT
LINK ADAPTER LPORT RPORT OPEN ALW
2207 A
A
M3UA
Step
Step 7
are no, continue the procedure with
IETF M3UA and SUA Configuration Procedures
EAGLE5 42.0.0
DUPLEX
SPEED MACTYPE AUTO MCAST
10
10
1030
1030
YES
7, or the open and alw parameter values of the
Step
802.3
NO
NO
DIX
NO
NO
Step 7
by entering the
YES
10.
464
Need help?
Do you have a question about the IP7 Secure Gateway and is the answer not in the manual?
Questions and answers