Tekelec IP7 Secure Gateway Administration Manual page 545

Database Administration Manual - IP7 Secure
Gateway
192.1.1.10
192.1.1.12
192.1.1.14
192.1.1.20
192.1.1.22
192.1.1.24
192.1.1.30
192.1.1.32
192.1.1.50
192.1.1.52
REMOTE IPADDR
150.1.1.5
IP Host table is (11 of 2048) 1% full
6. Display the IP links in the database by entering the rtrv-ip-lnk command.
The following is an example of the possible output.
rlghncxa03w 07-05-28 21:14:37 GMT EAGLE5 37.0.0
LOC PORT IPADDR
1303 A 192.1.1.10
1303 B --------------- --------------- HALF
1305 A 192.1.1.12
1305 B --------------- --------------- HALF
1313 A 192.1.1.14
1313 B --------------- --------------- HALF
2101 A 192.1.1.20
2101 B --------------- --------------- HALF
2103 A 192.1.1.22
2103 B --------------- --------------- HALF
2105 A 192.1.1.24
2105 B --------------- --------------- HALF
2205 A 192.1.1.30
2205 B --------------- --------------- HALF
2207 A 192.1.1.32
2207 B --------------- --------------- HALF
2213 A 192.1.1.50
2213 B --------------- --------------- HALF
2301 A 192.1.1.52
2301 B --------------- --------------- HALF
2305 A 192.3.3.33
2305 B --------------- --------------- HALF
IP-LNK table is (22 of 2048) 1% full.
If the required IP link, one that contains the desired IP address, is not shown in the rtrv-ip-lnk
output, add the IP link using the
assign the IP address of the IP link to the IP host name using the
continue the procedure with
If the required IP link is shown in the rtrv-ip-lnk output, but the IP host is not shown in the
rtrv-ip-host output in
Adding an IP Host
If the required IP host was shown in
output in this step. Perform
is assigned to the IP host.
Note: The rtrv-ip-host output must contain a host name for the association's lhost parameter
and a host name for the association's alhost parameter, if the alhost parameter will be specified
910-6278-001 Revision A, January 2012
IPNODE1-1201
GW105. NC. TEKELEC. COM
IPNODE1-1205
IPNODE2-1201
IPNODE2-1203
IPNODE2-1205
KC-HLR1
KC-HLR2
DN-MSC1
DN-MSC2
REMOTE HOST
NCDEPTECONOMIC_DEVELOPMENT. SOUTHEASTERN_COORIDOR_ASHVL. GOV
SUBMASK
255.255.255.128 HALF
255.255.255.0
255.255.255.0
255.255.255.0
255.255.255.0
255.255.255.0
255.255.255.0
255.255.255.0
255.255.255.0
255.255.255.0
255.255.255.0
Configuring an IP Link
Step 11.
Step 5, assign the IP address of the IP link to the IP host name using the
procedure, then continue the procedure with
Step
Step 7 to verify the application running on the card whose IP address
IETF M3UA and SUA Configuration Procedures
DUPLEX SPEED MACTYPE AUTO MCAST
10
10
---- ---
10
FULL 100
10
FULL 100
10
FULL 100
10
FULL 100
10
FULL 100
10
FULL 100
10
FULL 100
10
FULL 100
10
FULL 100
10
procedure. After the IP link has been added,
Adding an IP Host
Step
5, the required IP link is shown in the rtrv-ip-lnk
802.3 NO NO
DIX NO NO
DIX YES NO
DIX NO NO
DIX NO NO
DIX NO NO
DIX NO NO
DIX NO NO
DIX NO NO
DIX NO NO
DIX NO NO
DIX NO NO
DIX NO NO
DIX NO NO
DIX NO NO
DIX NO NO
DIX NO NO
DIX NO NO
DIX NO NO
DIX NO NO
DIX NO NO
DIX NO NO
procedure, then
11.
545