Tekelec IP7 Secure Gateway Administration Manual page 593

Database Administration Manual - IP7 Secure
Gateway
chg-sg-opts:sctpcsum=crc32c
When this command has successfully completed, the following message should appear.
rlghncxa03w 06-10-28 21:19:37 GMT EAGLE5 36.0.0
CHG-SG-OPTS: MASP A - COMPLTD
Continue the procedure by performing one of these actions.
If the sctpcsum parameter value was changed to either adler32 or crc32c, continue the
procedure with
If the sctpcsum parameter value was changed to percard, perform the
procedure to assign an sctpcsum parameter value to all the cards running the IPLIM or IPLIMI
applications. After the
procedure with
12. Verify that the SCTP checksum algorithm was changed using the rtrv-sg-opts command. The
SCTP checksum algorithm option value is shown in the SCTPCSUM parameter. The following is an
example of the possible output.
rlghncxa03w 06-10-28 21:16:37 GMT EAGLE5 36.0.0
SCTPCSUM:
The rtrv-sg-opts command output contains other fields that are not used by this procedure. If
you wish to see all the fields displayed by the rtrv-sg-opts command, see the rtrv-sg-opts
command description in the Commands Manual.
13. Change the value of the open parameter of the associations shown in
the chg-assoc command with the open=no parameter. For this example, enter this command.
chg-assoc:aname=assoc3:open=no
chg-assoc:aname=assoc6:open=no
When this command has successfully completed, this message should appear.
rlghncxa03w 06-10-28 09:12:36 GMT EAGLE5 36.0.0
CHG-ASSOC: MASP A - COMPLTD;
14. Change the value of the open parameter of the associations changed in
the chg-assoc command with the open=yes parameter. For this example, enter this command.
chg-assoc:aname=assoc3:open=yes
chg-assoc:aname=assoc6:open=yes
When this command has successfully completed, this message should appear.
rlghncxa03w 06-10-28 09:12:36 GMT EAGLE5 36.0.0
CHG-ASSOC: MASP A - COMPLTD;
15. Verify the checksum algorithm that is assigned to the associations shown in
the sctp -a pass command with the card location of the IP card specified in
of the associations specified in
pass:loc=1315:cmd= sctp -a assoc3
The following is an example of the possible output.
rlghncxa03w 10-12-28 21:16:37 GMT EAGLE5 43.0.0
Aname
910-6278-001 Revision A, January 2012
Step 12.
Configuring an IP Card
Step 13.
crc32c
Step 14. For this example, enter this command.
Local
IP Address
IETF M3UA and SUA Configuration Procedures
procedure has been performed, continue the
Step 7
Step 13
Local Primary
Port Address
Configuring an IP Card
to no by specifying
to yes by specifying
Step 14
by entering
Step 10 and the name
Remote
Port
593