Table 61: Valid Pvalue Parameter Values If Parm=2 - Tekelec IP7 Secure Gateway Administration Manual

Database Administration Manual - IP7 Secure
Gateway
Bits Enabled
Bit 6 - Broadcast Congestion Status
Change
* The system default value
If the parm value is 2, the bits used by the pvalue parameter are:
0 – ASP Active Notifications – controls the sending of ASP-Active notifications. If this value is
specified, an ASP-Default notification is sent when an ASP transitions to the ASP-ACTIVE state.
The default is not to send ASP-Active notifications.
1 – ASP Inactive Notifications – controls the sending of ASP-Inactive notifications. If this value
is specified, an ASP-Inactive notification is sent when an ASP transitions to the ASP-INACTIVE
state. The default is not to send ASP-Inactive notifications.
Note: To see the ASP activations and inactivations, bits 0 and 1 of the pvalue parameter value
need to be enabled. See
2 – ASP AS State Query – controls the sending of ASP/AS State notifications on request by an
ASP. If this value is specified, the EAGLE 5 ISS responds with ASP and AS state notifications
if the remote ASP sends ASP-UP or ASP-INACTIVE, while the local ASP is in the ASP-INACTIVE
state, or the remote ASP sends an ASP-ACTIVE notification while the local ASP is in the
ASP-ACTIVE state. The default is not to send ASP/AS state notifications.

Table 61: Valid PVALUE Parameter Values if PARM=2

parameter if the parm value is 2. The pvalue parameter value can be entered as a hexadecimal or
a decimal number.
Table 61: Valid PVALUE Parameter Values if PARM=2
Bits Enabled
None
Bit 0 - ASP Activate Notifications
Bit 1 - ASP Inactivate Notifications
Bit 0 - ASP Activate Notifications
Bit 1 - ASP Inactivate Notifications
910-6278-001 Revision A, January 2012
IPSG M2PA and M3UA Configuration Procedures
Bits Disabled
Table 61: Valid PVALUE Parameter Values if
Bits Disabled
Bit 0 - ASP Activate Notifications
Bit 1 - ASP Inactivate Notifications
Bit 2 - ASP AS State Query
Bit 1 - ASP Inactivate Notifications
Bit 2 - ASP AS State Query
Bit 0 - ASP Activate Notifications
Bit 2 - ASP AS State Query
Bit 2 - ASP AS State Query
Hexadecimal
PARM=2.
shows the values can be entered for the pvalue
Hexadecimal
Decimal
Value Value
Decimal
Value Value
h'0* 0*
h'1 1
h'2 2
h'3 3
1018