Tekelec IP7 Secure Gateway Administration Manual page 923

Database Administration Manual - IP7 Secure
Gateway
If the value of the open parameter value is being changed to yes and the association is not
assigned to a signaling link, perform one of these procedures.
If the ADAPTER value of the association is M2PA,
Link.
If the ADAPTER value of the association is M3UA,
Link.
After the association has been assigned to a signaling link, perform one of these actions.
If only the alw parameter is being specified with the open=yes parameter, continue the
procedure with
If the value of the rtxthr parameter is being changed, continue the procedure with
If the application assigned to the card is IPLIM or IPLIMI, perform
M2PA Association.
If the application assigned to the card is SS7IPGW or IPGWI, perform
M3UA or SUA
3. Change the value of the open parameter to no by specifying the chg-assoc command with the
open=no parameter.
For this example, enter these commands.
chg-assoc:aname=assoc2:open=no
chg-assoc:aname=assoc1:open=no
When these commands have successfully completed, this message should appear.
rlghncxa03w 06-10-28 09:12:36 GMT EAGLE5 36.0.0
CHG-ASSOC: MASP A - COMPLTD;
4. Display the association being changed by entering the rtrv-assoc command with the aname
parameter specified in
For this example, enter these commands.
rtrv-assoc:aname=assoc2
This is an example of the possible output.
rlghncxa03w 10-07-28 21:14:37 GMT EAGLE5 42.0.0
ANAME assoc2
LOC
ADAPTER
LHOST
ALHOST
RHOST
ARHOST
LPORT
ISTRMS
RMODE
RTIMES
OPEN
RHOSTVAL RELAXED
LSN
e5e6a
910-6278-001 Revision A, January 2012
Step 10.
Association.
Step 3 or selected in
1205 IPLNK PORT
M2PA VER
IPNODE2-1205
---
remotehost1
---
2048 RPORT
2 OSTRMS
LIN RMIN
10 CWMIN
NO ALW
M2PATSET
IPSG M2PA and M3UA Configuration Procedures
performAdding an IPSG M2PA Signaling
performAdding an IPSG M3UA Signaling
Step 1.
A LINK
M2PA RFC
2048
2 BUFSIZE
120 RMAX
3000 UAPS
YES RTXTHR
1
Changing the Attributes of an
Changing the Attributes of a
A
400
800
10
2000
Step 4.
923