Tekelec IP7 Secure Gateway Administration Manual page 906

Database Administration Manual - IP7 Secure
Gateway
Link set table is (8 of 1024) 1% full.
Perform these actions as necessary.
Perform the
shown in the rtrv-ls output whose IPGWAPC value is yes.
Perform one of these actions to change the MAXSLKTPS value (and RSVDSLKTPS value if
necessary) for any linksets shown in the rtrv-ls output whose IPSG value is yes.
If the ADAPTER value of the linkset is M2PA, perform the
procedure.
If the ADAPTER value of the linkset is M3UA, continue the procedure with
Perform one or both of these actions to increase the available TPS if needed.
An IPLIMx card that contains signaling links has to be removed. To perform this action, continue
the procedure with
Some ATM high-speed signaling links have to be removed. To perform this action, continue
the procedure with
If you do not wish to perform other actions to increase the available TPS and the available TPS will
allow the IPSG M3UA linkset to be changed, continue the procedure with
11. Reduce the MAX SLKTPS, and RSVDSLKTPS value if necessary, for the linksets displayed in
10 by entering the chg-ls command with the new maxslktps and rsvdslktps values. For this
example, enter these commands.
chg-ls:lsn=ipsglsn:maxslktps=3000
chg-ls:lsn=ipsglsn2:maxslktps=3000
Note: The rsvdslktps value must be less than or equal to the maxslktps value.
When this command has successfully completed, this message should appear.
rlghncxa03w 10-07-17 16:23:21 GMT
Link set table is ( 13 of 1024)
CHG-LS: MASP A - COMPLTD
12. Change the linkset by entering the chg-ls command with the name of the linkset and any of these
optional parameters and values.
if the ADAPTER, SLKTPS, ASNOTIF, LSUSEALM, and SLKUSEALM values will not be changed, do
not perform this step. Continue the procedure with
adapter = m3ua
rsvdslktps = 100 - 5000
maxslktps = 0 - 5000
tpsalmtype = rsvdslktps or maxslktps
lsusealm = 10 - 100
slkusealm = 10 - 100
asnotif = yes or no
For this example, enter this command.
910-6278-001 Revision A, January 2012
Configuring an IPGWx Linkset
Step 8.
Step 7.
IPSG M2PA and M3UA Configuration Procedures
procedure to change the IPTPS value for any linksets
EAGLE5 42.0.0
1% full
Step 16.
Changing an IPSG M2PA Linkset
Step 11.
Step 12.
Step
906