Tekelec IP7 Secure Gateway Administration Manual page 922

Database Administration Manual - IP7 Secure
Gateway
ANAME
swbel32
a2
a3
assoc1
assoc2
assoc3
assoc5
2. Enter the rtrv-card command with the location of the card that is hosting the M2PA or M3UA
association that will be changed in this procedure. For this example, enter these commands.
rtrv-card:loc=1205
This is an example of possible output.
rlghncxa03w 08-04-06 15:17:20 EST EAGLE5 38.0.0
CARD TYPE
1205 ENET
rtrv-card:loc=1201
This is an example of possible output.
rlghncxa03w 08-04-06 15:17:20 EST EAGLE5 38.0.0
CARD TYPE
1201 ENET
If the application assigned to the card is IPSG, shown in the APPL column, and the values of any
of these parameters are being changed: lport, rhost, rport, rmode, rmin, rmax, rtimes,
cwmin, istrms, ostrms, ver, m2patset, or uaps, continue the procedure by performing one
of these steps.
If the open parameter value for the association is yes, continue the procedure with
If the open parameter value for the association is no, continue the procedure with
If the application assigned to the card is IPSG, shown in the APPL column, and only the values of
the alw, open, or rtxthr parameters are being changed, continue the procedure by performing
one of these steps.
Note: If the adapter parameter value for the association is M3UA, the alw parameter cannot be
specified.
If only the values of the alw parameter is being changed, or the open parameter value is being
changed to no, continue the procedure with
If the value of the rtxthr parameter is being changed, continue the procedure with
If the value of the open parameter value is being changed to yes, the association must be
assigned to a signaling link. If the association is assigned to a signaling link, the signaling link
value is shown in the LINK column in the rtrv-assoc output, in
not assigned to a signaling link, dashes are shown in the LINK column in the rtrv-assoc
output. If association is assigned to a signaling link, perform one of these actions.
If only the alw parameter is being specified with the open=yes parameter, continue the
procedure with
If the value of the rtxthr parameter is being changed, continue the procedure with
910-6278-001 Revision A, January 2012
CARD IPLNK
LOC PORT LINK ADAPTER LPORT RPORT OPEN ALW
1201 A A M3UA
1305 A A SUA
1307 A A SUA
1201 A A M3UA
1205 A A M2PA
1205 A B2 M2PA
1205 A A3 M2PA
APPL LSET NAME
IPSG e5e6a
e5e6a
APPL LSET NAME
IPSG ipsgm3ua1
Step 10.
IPSG M2PA and M3UA Configuration Procedures
1030 2345 YES
1030 2345 YES
1030 2346 YES
2000 1030 YES
2048 2048 YES
3000 3000 YES
1500 3000 YES
LINK SLC LSET NAME
A 0 e5e6a
A3 2
LINK SLC LSET NAME
A 0
Step 10.
YES
YES
YES
YES
YES
YES
YES
LINK SLC
B2 1
LINK SLC
Step 3.
Step 4.
Step
Step 1. If the association is
Step
4.
4.
922