Figure 96: Configuring An Ip Card - Tekelec IP7 Secure Gateway Administration Manual

Database Administration Manual - IP7 Secure
Gateway
chg-ip-card:loc=<card location> command
with at least one of these parameters:
:srchordr = <local, srvr, srvronly>
:dsna = <IP address for domain server A>
:dsnb = <IP address for domain server B>
:domain = <domain name>
:defrouter = <IP address of the default
:rstdomain = <yes, no>
:sctpcsum = <adler32, crc32c>
(See Notes 1 through 4)
rtrv-ip-card command with this
:loc = <the card location specified
with the chg-ip-card command>
Was the state
of the card changed on
alw-card:loc=<card
location> command
rept-stat-card:loc=<card
location> command
Sheet 4 of 4

Figure 96: Configuring an IP Card

910-6278-001 Revision A, January 2012
From
Sheet 3
Enter the Notes:
1. Either the domain or rstdomain parameters can
be specified, but not both.
2. The IP address of the Ethernet interface must be
shown in the rtrv-ip-lnk output before the defrouter
parameter can be specified. The network portion of
the IP address assigned to one of the Ethernet
Interfaces on the IP card must match the network
router>
portion of the default router's IP address.
3. Specifying the IP address 0.0.0.0 for the dsna or
dsnb parameters, removes the IP address for
Domain Server A (dsna) or Domain Server B
(dsnb).
4. The sctpcsum parameter can be specified only if
Enter the
the SCTPCSUM value shown in the rtrv-sg-opts
output is percard.
parameter.
No
Sheet 1?
Yes
Enter the
Enter the
IPSG M2PA and M3UA Configuration Procedures
Was the state
No
of the signaling link
changed on Sheet 1?
Yes
Enter the
dact-slk:loc=<card location of
the signaling link>
:link=<signaling link assigned
to the card> command
Enter the
rept-stat-slk:loc=<card
location of the signaling link>
:link=<signaling link assigned
to the card> command
chg-db:action=backup:dest=fixed
Enter the
command
723