Tekelec IP7 Secure Gateway Administration Manual page 893

Database Administration Manual - IP7 Secure
Gateway
From
Sheet 3
M2PA
the ADAPTER value
of the linksets that you
wish to change?
Enter the chg-ls
command with this
mandatory parameter.
:lsn=<the name of the
IPSG M2PA linkset >
and with at least one of
these optional
parameters.
:rsvdslktps = <100
5000>
:maxslktps = <0
If more than one IPSG
M2PA linkset will be
changed, repeat this step
for each linkset.
Sheet 4 of 5
910-6278-001 Revision A, January 2012
Enter the rept-stat-iptps
command.
Enter the rtrv-ls command
with this parameter.
:lsn=<linkset name shown in
the rept-stat-iptps output>
Repeat this step for each
linkset shown in the
rept-stat-iptps output.
Are any linksets
No
shown with the value
yes in the IPGWAPC
column?
What is
Yes
M3UA
Change the MAXSLKTPS
values of the IPSG linksets
(and RSVDSLKTPS values if
necessary) of some or all of the
IPSG M3UA linksets shown in
the rtrv-ls output by performing
the Changing an IPSG M3UA
Linkset" procedure.
5000>
IPSG M2PA and M3UA Configuration Procedures
Are any
linksets shown in
No
the rept-stat-iptps
output, other than the
linkset that is being
changed?
Yes
Change the IP TPS
values of some or all the
existing IPGWx linksets
Yes
shown in the rtrv-ls
output by performing the
Configuring an IPGWx
Linkset" procedure.
Do you
wish to change
Yes
the MAXSLKTPS
values on any of
the IPSG
linksets?
No
Do you wish
to perform other
actions?
Yes
To
Sheet 3
Are any
linksets shown with
the value yes in the
IPSG column?
No
No
To
Sheet 5
893