Tekelec IP7 Secure Gateway Administration Manual page 828

Database Administration Manual - IP7 Secure
Gateway
IP Appl Sock/Assoc table is (4 of 4000) 1% full
Assoc Buffer Space Used (200 KB of 1600 KB) on LOC = 2305
rtrv-assoc:lhost=ipnode2-1201
The following is an example of the possible output.
rlghncxa03w 06-10-28 21:14:37 GMT EAGLE5 36.0.0
ANAME
m3ua1
IP Appl Sock/Assoc table is (4 of 4000) 1% full
Assoc Buffer Space Used (16 KB of 800 KB) on LOC = 2101
If no associations referencing the host name being removed in this procedure are shown in this
step, continue the procedure with
Any associations referencing the host name must either be removed or the host name assigned to
the association must be changed.
To remove the associations, perform the
Continue the procedure with
To change the host name assigned to the associations, perform the
IPSG Association
Continue the procedure with
changed.
5. Delete IP host information from the database by entering the dlt-ip-host command.
For example, enter these commands.
dlt-ip-host:host=gw100.nc.tekelec.com
dlt-ip-host:host="ipnode2-1201"
When these commands have successfully completed, the following message should appear.
rlghncxa03w 06-10-28 21:19:37 GMT EAGLE5 36.0.0
DLT-IP-HOST: MASP A - COMPLTD
6. Verify the changes by entering the rtrv-ip-host command with the host name specified in
5.
For this example, enter these commands.
rtrv-ip-host:host=gw100.nc.tekelec.com
rtrv-ip-host:host="ipnode2-1201"
The following is an example of the possible output.
rlghncxa03w 09-07-28 21:20:37 GMT EAGLE5 41.1.0
No matching entries found.
IP Host table is (10 of 2048) 1% full
7. Back up the new changes using the chg-db:action=backup:dest=fixed command.
910-6278-001 Revision A, January 2012
CARD IPLNK
LOC PORT LINK ADAPTER LPORT RPORT OPEN ALW
2101 A A
Step 5.
Step 5 after the associations have been removed.
procedure.
Step 5 after the host name assigned to the associations have been
IPSG M2PA and M3UA Configuration Procedures
M3UA 2000 2000
Removing an IPSG Association
NO NO
procedure.
Changing the Host Values of an
Step
828