Tekelec IP7 Secure Gateway Administration Manual page 843

Database Administration Manual - IP7 Secure
Gateway
If the LSRESTRICT option is on and the number of signaling links assigned to the linkset will be
equal to or greater than the value of the tfatcabmlq parameter value of the linkset if the signaling
link is removed, the "Configuring the Restricted Linkset Option" procedure has been performed,
or if the LSRESTRICT value is off, continue the procedure by performing one of these steps.
If the OPEN or ALW values for the associations is YES, continue the procedure with
If the OPEN and ALW values for the associations is NO, continue the procedure with
5. Change the tfatcabmlq parameter value of the linkset to 0 by entering the chg-ls command
with the name of the linkset that contains the signaling link that is being removed and the
tfatcabmlq parameters. For this example, enter this command.
chg-ls:lsn=ls17:tfatcabmlq=0
When this command has successfully completed, this message should appear.
rlghncxa03w 10-07-07 08:41:12 GMT
Link set table is (20 of 1024) 2% full.
CHG-LS: MASP A - COMPLTD
Continue the procedure by performing one of these steps.
If the OPEN or ALW values for the associations is YES, continue the procedure with
If the OPEN and ALW values for the associations is NO, continue the procedure with
6. Change the value of the open and alw parameters to no by specifying the chg-assoc command
with the open=no and alw=no parameters, as necessary.
For this example, enter this command.
chg-assoc:aname=assoc1:open=no:alw=no
When this command has successfully completed, this message should appear.
rlghncxa03w 06-10-28 09:12:36 GMT EAGLE5 36.0.0
CHG-ASSOC: MASP A - COMPLTD;
7. Deactivate the link to be removed using the dact-slk command, using the output from
obtain the card location and link parameter value of the signaling link to be removed.
For this example, enter these commands.
dact-slk:loc=2204:link=a
When this command has successfully completed, this message should appear.
rlghncxa03w 06-10-07 08:41:12 GMT
Deactivate Link message sent to card
8. Verify that the link is out of service - maintenance disabled (OOS-MT-DSBLD) using the
rept-stat-slk command with the card location and link parameter values specified in
7.
For this example, enter this command.
rept-stat-slk:loc=2204:link=a
910-6278-001 Revision A, January 2012
IPSG M2PA and M3UA Configuration Procedures
EAGLE5 42.0.0
EAGLE5 36.0.0
Step 6.
Step 7.
Step 6.
Step 7.
Step 1 to
Step
843