Tekelec IP7 Secure Gateway Administration Manual page 567

Database Administration Manual - IP7 Secure
Gateway
as2
as3
AS table is (2 of 250) 1% full.
Note: If the mode parameter will not be specified with the chg-as command in
the procedure with
2. Display one of the associations assigned to the application server shown in
rtrv-assoc command and specifying the association name shown in the rtrv-as output in
1.
For this example, enter this command.
rtrv-assoc:aname=assoc1
This is an example of possible output.
rlghncxa03w 09-05-28 09:12:36 GMT EAGLE5 41.0.0
ANAME assoc1
LOC
ADAPTER
LHOST
ALHOST
RHOST
ARHOST
LPORT
ISTRMS
RMODE
RTIMES
OPEN
RHOSTVAL RELAXED
ASNAMES
as1
IP Appl Sock table is (4 of 4000) 1% full
Assoc Buffer Space Used (16 KB of 800 KB) on LOC = 1203
Note: If the value of the open parameter shown in this step is no, continue the procedure with
Step 5.
3. Change the value of the open parameter to no by specifying the chg-assoc command with the
open=no parameter.
For this example, enter this command.
chg-assoc:aname=assoc1:open=no
When this command has successfully completed, this message should appear.
rlghncxa03w 06-10-28 09:12:36 GMT EAGLE5 36.0.0
CHG-ASSOC: MASP A - COMPLTD
Note: If all the associations assigned to the application server been displayed, continue the procedure
with Step 5.
4. Repeat Step 2
5. Change the application server in the database using the chg-as command.
For this example, enter this command
910-6278-001 Revision A, January 2012
OVERRIDE
LOADSHARE
Step 5.
1203 IPLNK PORT
M3UA VER
gw105.nc.tekelec.com
---
gw100.ncd-economic-development.southeastern-corridor-ash.gov
---
1030 RPORT
2 OSTRMS
LIN RMIN
10 CWMIN
YES ALW
and Step 3 for all associations assigned to the application server being changed.
IETF M3UA and SUA Configuration Procedures
assoc6
10 assoc7
10 assoc4
A
M3UA RFC
2345
2
120
3000
YES
Step 5, continue
Step 1 using the
LINK A
BUFSIZE 16
RMAX 800
UAPS 10
RTXTHR 10000
Step
567