Tekelec IP7 Secure Gateway Administration Manual page 907

Database Administration Manual - IP7 Secure
Gateway
chg-ls:lsn=lssg1101:slktps=500:lsusealm=60:slkusealm=70
chg-ls:lsn=lssg1101:rsvdslktps=500:maxslktps=3000:tpsalmtype=maxslktps
:lsusealm=60:slkusealm=70
Note: The rsvdslktps value must be less than or equal to the maxslktps value.
When the chg-ls command has successfully completed, this message should appear.
rlghncxa03w 06-10-17 16:23:21 GMT
Link set table is ( 13 of 1024)
CHG-LS: MASP A - COMPLTD
Note: There are other optional parameters that can be specified with the chg-ls command, but
are not required for an IPSG M3UA linkset. These parameters and their usage are discussed in the
Other Optional Parameters section of this procedure.
If you do not wish to change the RCONTEXT value of the linkset, continue the procedure with
17.
If you wish to change the RCONTEXT value of the linkset, continue the procedure with by performing
one of these steps.
If the ADAPTER value of the linkset was changed to m3ua in
Step 16.
If the ADAPTER value of the linkset was m3ua when this procedure was started, and the linkset
contains signaling links, continue the procedure with
If the ADAPTER value of the linkset was m3ua when this procedure was started, and the linkset
does not contains signaling links, continue the procedure with
If the ADAPTER value of the linkset was m3ua when this procedure was started, the RCONTEXT
value is being removed from the linkset, perform one of these actions. If the linkset does not
contains signaling links, continue the procedure with
links, remove the signaling links from the linkset by performing the
Signaling Link
with Step 16.
13. Deactivate all the signaling links in the linkset by entering the dact-slk command with the
location and link value of each signaling link in the linkset. For this example, enter these commands.
dact-slk:loc=1101:link=a2
dact-slk:loc=1101:link=a7
When the dact-slk command has successfully completed, this message should appear.
rlghncxa03w 08-04-25 06:49:44 EST
Deactivate Link message sent to card
Command Completed.
14. Display the signaling links that the association, shown in the rtrv-ls output in
to by entering the rtrv-slk command with the name of the association that will be added to the
signaling link. For this example, enter this command.
rtrv-slk:aname=m3ua2
910-6278-001 Revision A, January 2012
procedure. After the signaling links have been removed, continue the procedure
IPSG M2PA and M3UA Configuration Procedures
EAGLE5 37.5.0
1% full
Step 12
Step 13.
Step 16. If the linkset does contain signaling
38.0.0
continue the procedure with
Step 16.
Removing an IPSG M3UA
Step 2, is assigned
Step
907