Tekelec IP7 Secure Gateway Administration Manual page 980

Database Administration Manual - IP7 Secure
Gateway
If the ADAPTER value of the associations shown in the rtrv-assoc output is M3UA, do not perform
the remainder of this procedure. Perform the
IPSG M3UA Associations
associations.
4. Change the SCTP checksum option in the database using the chg-sg-opts command. For this
example, enter this command.
chg-sg-opts:sctpcsum=crc32c
When this command has successfully completed, the following message should appear.
rlghncxa03w 06-10-28 21:19:37 GMT EAGLE5 36.0.0
CHG-SG-OPTS: MASP A - COMPLTD
Continue the procedure by performing one of these actions.
If the sctpcsum parameter value was changed to either adler32 or crc32c, continue the
procedure with
If the sctpcsum parameter value was changed to percard, perform the
procedure to assign an sctpcsum parameter value to all the cards containing IPSG M2PA
associations. After the
procedure with
5. Verify that the SCTP checksum algorithm was changed using the rtrv-sg-opts command. The
SCTP checksum algorithm option value is shown in the SCTPCSUM parameter. The following is an
example of the possible output.
rlghncxa03w 06-10-28 21:16:37 GMT EAGLE5 36.0.0
SCTPCSUM:
The rtrv-sg-opts command output contains other fields that are not used by this procedure. If
you wish to see all the fields displayed by the rtrv-sg-opts command, see the rtrv-sg-opts
command description in the Commands Manual.
6. Place the signaling links assigned to the IPSG card out of service using the dact-slk command,
specifying the LOC and LINK values shown in
dact-slk:loc=1308:link=a1
dact-slk:loc=1308:link=b
dact-slk:loc=1308:link=b2
When these commands have successfully completed, this message appears.
rlghncxa03w 06-10-12 09:12:36 GMT EAGLE5 36.0.0
Deactivate Link message sent to card
7. Change the value of the open parameter of the associations shown in
the chg-assoc command with the open=no parameter. For this example, enter this command.
chg-assoc:aname=assoc2:open=no
chg-assoc:aname=assoc4:open=no
chg-assoc:aname=assoc5:open=no
910-6278-001 Revision A, January 2012
procedure to change the SCTP checksum algorithm for IPSG M3UA
Step 5.
Configuring an IP Card
Step 6.
crc32c
IPSG M2PA and M3UA Configuration Procedures
Changing the SCTP Checksum Algorithm Option for
procedure has been performed, continue the
Step 3. For this example, enter these commands.
Configuring an IP Card
Step 3 to no by specifying
980