Tekelec IP7 Secure Gateway Administration Manual page 166

Database Administration Manual - IP7 Secure
Gateway
When this command has successfully completed, this message should appear.
rlghncxa03w 06-10-07 08:41:17 GMT
DLT-SLK: MASP A - COMPLTD
Note: If removing the signaling link will result in 700 or less signaling links in the database and
the OAMHCMEAS value in the rtrv-measopts output is on, the scheduled UI measurement reports
will be enabled.
14. Verify the changes using the rtrv-slk command with the card location and link values specified
in Step 13. For this example, enter these commands.
rtrv-slk:loc=2205:link=a
rtrv-slk:loc=2204:link=a
When the rtrv-slk command has completed, the specified signaling link is not shown in the
rtrv-slk output, as shown in this example.
rlghncxa03w 09-09-18 13:43:31 GMT EAGLE5 41.1.0
E2373 Cmd Rej: Link is unequipped in the database
15. Back up the new changes using the chg-db:action=backup:dest=fixed command. These
messages should appear, the active Maintenance and Administration Subsystem Processor (MASP)
appears first.
BACKUP (FIXED) : MASP A - Backup starts on active MASP.
BACKUP (FIXED) : MASP A - Backup on active MASP to fixed disk complete.
BACKUP (FIXED) : MASP A - Backup starts on standby MASP.
BACKUP (FIXED) : MASP A - Backup on standby MASP to fixed disk complete.
910-6278-001 Revision A, January 2012
IETF M2PA Configuration Procedures
EAGLE5 36.0.0
166