Tekelec IP7 Secure Gateway Administration Manual page 718

Database Administration Manual - IP7 Secure
Gateway
GETCOMM:
SETCOMM:
TRAPCOMM:
SCTPCSUM:
IPGWABATE:
UAMEASUSEDFTAS: NO
If the sctpcsum parameter value in the rtrv-sg-opts output is percard, continue the procedure
with Step 11.
If the sctpcsum parameter value in the rtrv-sg-opts output is adler 32 or crc32c, perform
the one of these procedures to change the sctpcsum parameter value to percard, depending on
the ADAPTER value of the association.
Changing the SCTP Checksum Algorithm Option for IPSG M2PA Associations
Changing the SCTP Checksum Algorithm Option for IPSG M3UA Associations
After the SCTP checksum algorithm has been changed, continue the procedure with
11. Change the IP stack parameters associated with an IP card in the database using the chg-ip-card
command.
For this example, enter this command.
chg-ip-card:loc=1201:srchordr=local:dnsa=192.1.1.40:domain=nc.tekelec.com
:sctpcsum=adler32
When this command has successfully completed, the following message should appear.
rlghncxa03w 06-10-28 21:20:37 GMT EAGLE5 36.0.0
CHG-IP-CARD: MASP A - COMPLTD
12. Verify the new IP parameters associated with the IP card that was changed in
the rtrv-ip-card command with the card location specified in
For this example, enter this command.
rtrv-ip-card:loc=1201
The following is an example of the possible output.
rlghncxa03w 08-06-28 21:17:37 GMT EAGLE5 39.0.0
LOC 1201
SRCHORDR
DNSA
DNSB
DEFROUTER ---------------
DOMAIN
SCTPCSUM
BPIPADDR
BPSUBMASK ---------------
Note: If Step 7
13. Allow the IP card that was inhibited in
For example, enter this command.
alw-card:loc=1201
910-6278-001 Revision A, January 2012
public
private
public
adler32
NO
LOCAL
192.1.1.40
---------------
NC. TEKELEC. COM
adler32
---------------
was not performed, continue the procedure with
IPSG M2PA and M3UA Configuration Procedures
Step 7 by using the alw-card command.
Step
Step 11 by entering
Step 11.
Step 15.
11.
718