Tekelec IP7 Secure Gateway Administration Manual page 739

Database Administration Manual - IP7 Secure
Gateway
Note: The IP link is shown by the
entries in the CARD LOC and
IPLINK PORT columns. The
ADAPTER value of the association
must be M2PA .
rtrv-assoc command with this
:loc = <the card location that
will host the new
Less
than 32
To
Sheet 3
This is the maximum
associations the IPSG
card may contain.
Choose another IPSG
Sheet 1 of 4
910-6278-001 Revision A, January 2012
rtrv-assoc output? (See
rtrv-card command with this
:loc= <card location from the
Enter the
IPSG
parameter.
association>
The links and host assigned to
How many
this card cannot be used in this
associations are
displayed?
32
use the card shown in the
number of IPSG
rtrv-card output to configure an
card.
Choose another card from the
rtrv-assoc output whose
adapter value is M2PA .
IPSG M2PA and M3UA Configuration Procedures
Enter the
rtrv-assoc command.
Is the required
No
IP link shown in the
the Note)
Yes
Enter the
parameter.
rtrv-assoc output>
What is the
value in the TYPE
column of the rtrv-card
output?
IPLIM, IPLIMI
procedure.
Do you wish to
Yes
M2PA association ?
No
To
Sheet 2
Perform the Adding
an M2PA Association"
procedure.
739