Tekelec IP7 Secure Gateway Administration Manual page 1007

Database Administration Manual - IP7 Secure
Gateway
rept-stat-assoc command with this parameter:
:aname = <the association aname specified in
Sheet 3 of 4
910-6278-001 Revision A, January 2012
From
Sheet 2
Have the IP near end node configure all
associations attached to the card specified
in the pass command on Sheet 2 to use the
new algorithm. Verify that the associations
will use the algorithm.
At the EAGLE 5 ISS, enter the
act-slk command with these
parameters.
:loc=<location of the card specified in
the pass command on Sheet 2>
:link=a
At the EAGLE 5 ISS, enter the
the chg-assoc command on Sheet 2>
Enter the pass:loc=<card location
specified in the act-slk
command>:cmd="netstat -p sctp"
command
Yes
Are any errors
displayed
No
To
Sheet 4
IPSG M2PA and M3UA Configuration Procedures
Enter the rept-stat-slk
command
At the IP near end node, connect one
of the associations attached to the
card specified in the act-slk
command.
Contact the Customer Care
Center. Refer to the
"Customer Care Center"
section in Chapter 1 for the
contact information.
1007