Tekelec IP7 Secure Gateway Administration Manual page 898

Database Administration Manual - IP7 Secure
Gateway
rtrv-ls:lsn=lsgw1101
This is an example of the possible output.
rlghncxa03w 10-07-20 13:34:40 GMT
LSN
lssg1101
---------------- -----------
RANDSLS
off
IPSG
yes
ADAPTER
m3ua
TPSALM
rsvdslktps 100%
RCONTEXT
100
LOC
1101 A2
1105 A7
Link set table is (13 of 1024) 1% full.
If you do not wish to change this linkset, choose another linkset from
If this linkset will be changed, perform one of these steps.
If the IPGWAPC value of the linkset is yes, the linkset must be removed from the database and
then an IPSG M3UA linkset must be added. Perform the "Removing a Linkset Containing SS7
Signaling Links" procedure in the Database Administration Manual - SS7 to remove the linkset.
After the linkset has been removed, perform the
add the IPSG M3UA linkset. After the IPSG M3UA linkset has been added, perform the
an IPSG M3UA Signaling Link
M3UA linkset. This procedure is finished.
If the IPGWAPC value of the linkset is no, continue the procedure by performing one of these
steps.
If the LST value of the linkset is PRX, the linkset must be removed from the database and
then an IPSG M3UA linkset must be added. Perform the "Removing a Linkset Containing
SS7 Signaling Links" procedure in the Database Administration Manual - SS7 to remove the
linkset. After the linkset has been removed, perform the
procedure to add the IPSG M3UA linkset. After the IPSG M3UA linkset has been added,
perform the
links to the new IPSG M3UA linkset. This procedure is finished.
If the LST value of the linkset is a value other than PRX and the IPSG value of the linkset is
no, remove the signaling links from the linkset by performing these procedures as necessary.
Removing an SS7 Signaling Link in the Database Administration Manual - SS7.
910-6278-001 Revision A, January 2012
APCA (SS7) SCRN SET SET BEI LST LNKS ACT MES DIS SLSCI NIS
008-012-003 none 1
SPCA CLLI
IPGWAPC GTTMODE
no CdPA
RSVDSLKTPS
1000
LSUSEALM
ASNOTIF
no
LINK SLC TYPE
0 IPSG
1 IPSG
procedure to add IPSG M3UA signaling links to the new IPSG
Adding an IPSG M3UA Signaling Link
IPSG M2PA and M3UA Configuration Procedures
EAGLE5 42.0.0
L3T SLT
1 no A 2
TFATCABMLQ MTPRSE ASL8
2
CGGTMOD
no
MAXSLKTPS
4000
SLKUSEALM
80%
NUMSLKALW NUMSLKRSTR
1 1
ANAME
mu3a2
m3ua3
Adding an IPSG M3UA Linkset
Adding an IPSG M3UA Linkset
procedure to add IPSG M3UA signaling
GWS GWS GWS
off off off no
--- no
NUMSLKPROH
1
Step 1 and repeat this steps.
procedure to
off
Adding
898