Figure 76: Changing The Sctp Checksum Algorithm Option For M3Ua And Sua Associations - Tekelec IP7 Secure Gateway Administration Manual

Database Administration Manual - IP7 Secure
Gateway
At the IP near end node, connect all
of the other associations attached to
the card specified in the act-slk and
pass commands on Sheet 3.
At the EAGLE 5 ISS, enter this
pass:loc=<location of the card specified
in the act-slk and pass commands on
Sheet 3>:cmd="msucount -l"
At the IP near end node, activate all
of the other associations attached to
the card specified in the pass
Have all the cards running
the SS7IPGW or IPGWI applications
been updated with the new SCTP
checksum algorithm?
chg-db:action=backup:dest=fixed
This procedure is
Sheet 4 of 4

Figure 76: Changing the SCTP Checksum Algorithm Option for M3UA and SUA Associations

910-6278-001 Revision A, January 2012
From
Sheet 3
At the IP near end node, activate one
card specified in the act-slk and pass
command.
command.
No
Yes
Enter the
command
Does the EAGLE 5
No
ISS contain cards running
the IPSG application?
finished.
Yes
IETF M3UA and SUA Configuration Procedures
of the associations attached to the
commands on Sheet 3.
Enter this command for each association assigned
to the card.
pass:loc=<location of the card specified in the
previous pass command>:cmd="msucount -a
<association name specified in the rept-stat-assoc
command on Sheet 3>"
Is traffic flowing over the
Yes
association specified in the
previous pass command?
To
Sheet 1
Does the EAGLE 5
ISS contain cards running
the IPLIM or IPLIMI
applications?
No
Perform the Changing the SCTP
Checksum Algorithm Option for IPSG
M3UA Associations" and Changing
the SCTP Checksum Algorithm Option
for IPSG M2PA Associations"
procedures in Chapter 6.
No
Contact the Customer Care
Center. Refer to the
"Customer Care Center"
section in Chapter 1 for the
contact information.
Yes
Perform the Changing
the SCTP Checksum
Algorithm Option for
M2PA Associations"
procedure in Chapter 5.
607