Tekelec IP7 Secure Gateway Administration Manual page 568

Database Administration Manual - IP7 Secure
Gateway
chg-as:asname=as1:mode=override:tr=1000
This is an example of possible inputs and outputs:
rlghncxa03w 06-10-28 09:12:36 GMT EAGLE5 36.0.0
CHG-AS: MASP A - COMPLTD;
6. Verify the changes using the rtrv-as command.
This is an example of possible output.
rlghncxa03w 06-10-28 09:12:36 GMT EAGLE5 36.0.0
AS Name
as1
as2
as3
AS table is (2 of 250) 1% full
Note: If the value of the open parameter was not changed in
Step 8.
7. Change the value of the open parameter to yes by specifying the chg-assoc command with the
open=yes parameter.
For this example, enter this command.
chg-assoc:aname=assoc1:open=yes
When this command has successfully completed, this message should appear.
rlghncxa03w 06-10-28 09:12:36 GMT EAGLE5 36.0.0
CHG-ASSOC: MASP A - COMPLTD
Repeat this step for all associations that were changed in
8. Back up the new changes, using the chg-db:action=backup:dest=fixed command.
These messages should appear; the active Maintenance and Administration Subsystem Processor
(MASP) appears first.
BACKUP (FIXED) : MASP A - Backup starts on active MASP.
BACKUP (FIXED) : MASP A - Backup on active MASP to fixed disk complete.
BACKUP (FIXED) : MASP A - Backup starts on standby MASP.
BACKUP (FIXED) : MASP A - Backup on standby MASP to fixed disk complete.
910-6278-001 Revision A, January 2012
Mode Tr ms
OVERRIDE 1000
OVERRIDE 10
LOADSHARE 10
IETF M3UA and SUA Configuration Procedures
Association Names
assoc1
assoc2
assoc3
assoc5
assoc6
assoc7
assoc4
Step 3, continue the procedure with
Step 3.
568