Removing An Ipsg Linkset; Figure 104: Removing An Ipsg Card - Tekelec IP7 Secure Gateway Administration Manual

Database Administration Manual - IP7 Secure
Gateway
Enter the rtrv-card
command
The card being removed in this
procedure must be running the
IPSG application. Select one of
these cards.

Figure 104: Removing an IPSG Card

Removing an IPSG Linkset

This procedure is used to remove a IPSG linkset from the database using the dlt-ls command. An
IPSG linkset is a linkset whose ipsg parameter value is yes.
910-6278-001 Revision A, January 2012
Enter the rtrv-ls command with
this parameter:
:lsn=<the name of the linkset
shown in the LSET NAME column
for the card being removed>
M2PA
ADAPTER value assigned
Perform the Removing an
IPSG-M2PA Signaling Link"
procedure in this chapter to
remove the signaling links that
are assigned to the card being
removed.
Repeat this step for each
signaling link assigned to the
card.
Enter the dlt-card command with
this parameter:
:loc=<location of the card being
Enter the rtrv-card command with
this parameter:
:loc=<card location from the
chg-db:action=backup:dest=fixed
IPSG M2PA and M3UA Configuration Procedures
What is the
M3UA
to the linkset?
Perform the Removing an
IPSG-M3UA Signaling Link"
procedure in this chapter to
remove the signaling links that
are assigned to the card being
removed.
Repeat this step for each
signaling link assigned to the
card.
removed>
previous step>
Enter the
command
812