Tekelec IP7 Secure Gateway Administration Manual page 523

Database Administration Manual - IP7 Secure
Gateway
From
Sheet 1
rtrv-card command
performed?
Is a signaling
link assigned to the card,
shown in the LSET NAME and
LINK columns in the rtrv-card
output, or shown in the
rtrv-slk output?
Perform the "Adding an IPGWx
Signaling Link" procedure in this chapter
to add the required signaling link.
Note: If the open parameter value is being changed to
yes, the association must contain values for the lhost,
lport, rhost, and rport parameters. A signaling link
containing the loc and link value that is assigned to the
association must be provisioned in the database.
Sheet 2 of 8
910-6278-001 Revision A, January 2012
Are only the
open, alw, or rtxthr
parameter values being
changed?
Yes
Is the open
Yes
parameter value being
changed to yes?
(See the Note)
Was the
No
Enter the rtrv-slk command
Yes
with this parameter:
:loc = <the location of the
card containing the
association that will be
changed>
Yes
No
IETF M3UA and SUA Configuration Procedures
No
To
Sheet 4
No
To
Sheet 3
To
Sheet 3
523