Tekelec IP7 Secure Gateway Administration Manual page 335

Database Administration Manual - IP7 Secure
Gateway
2105 B --------------- --------------- HALF
2205 A 192.1.1.30
2205 B --------------- --------------- HALF
2207 A 192.1.1.32
2207 B --------------- --------------- HALF
2213 A 192.1.1.50
2213 B --------------- --------------- HALF
2301 A 192.1.1.52
2301 B --------------- --------------- HALF
IP-LNK table is (20 of 2048) 1% full.
Note: If the ipaddr=0.0.0.0 is not being specified in this procedure, continue the procedure
with Step 3.
2. If IP address information is being added or changed (not deleted) in the link parameters, verify
that the IP address is present in the IP host table by using the rtrv-ip-host:display=all
command.
The following is an example of the possible output.
rlghncxa03w 08-12-28 21:15:37 GMT EAGLE5 40.0.0
LOCAL IPADDR
192.1.1.10
192.1.1.12
192.1.1.14
192.1.1.20
192.1.1.22
192.1.1.24
192.1.1.30
192.1.1.32
192.1.1.50
192.1.1.52
REMOTE IPADDR
150.1.1.5
IP Host table is (11 of 2048) 1% full
If the current IP address of the IP link is shown in the rtrv-ip-host output, remove the host
assigned to the IP address by performing the
procedure.
3. To change IP link parameters, the signaling link to the IP card and the IP card have to be inhibited.
Display the signaling link associated with the card shown in
specifying the card location.
For this example, enter this command.
rtrv-slk:loc=1201
This is an example of the possible output.
rlghncxa03w 06-10-19 21:17:04 GMT EAGLE5 36.0.0
LOC LINK LSN
1201 A nc001
4. Retrieve the status of the signaling link assigned to the IP card to be changed using the
rept-stat-slk command.
910-6278-001 Revision A, January 2012
255.255.255.0
255.255.255.0
255.255.255.0
255.255.255.0
LOCAL HOST
IPNODE1-1201
IPNODE1-1203
IPNODE1-1205
IPNODE2-1201
IPNODE2-1203
IPNODE2-1205
KC-HLR1
KC-HLR2
DN-MSC1
DN-MSC2
REMOTE HOST
NCDEPTECONOMIC_DEVELOPMENT. SOUTHEASTERN_COORIDOR_ASHVL. GOV
SLC TYPE
0 SS7IPGW
IETF M3UA and SUA Configuration Procedures
10
FULL 100
10
FULL 100
10
FULL 100
10
FULL 100
10
Removing an IP Host Assigned to an IPGWx Card
Step 1 using the rtrv-slk command
DIX NO NO
DIX NO NO
DIX NO NO
DIX NO NO
DIX NO NO
DIX NO NO
DIX NO NO
DIX NO NO
DIX NO NO
335