Tekelec IP7 Secure Gateway Administration Manual page 1006

Database Administration Manual - IP7 Secure
Gateway
From
Sheet 1
What will the
new sctpcsum value
Enter the
chg-sg-opts:sctpcsum=<adler32, crc32c>
command
Enter the rtrv-sg-opts
command
Enter the chg-assoc command with these
parameters:
:aname = <aname value from the rtrv-assoc
output>
:open = no.
Repeat this step for each association shown in
the rtrv-assoc output on Sheet 1.
Enter the chg-assoc command with these
parameters:
:aname = <aname value from the rtrv-assoc
output>
:open = yes.
Repeat this step for each association shown in
the rtrv-assoc output on Sheet 1.
Contact the Customer Care
Center. Refer to the "Customer
Care Center" section in Chapter 1
for the contact information.
Sheet 2 of 4
910-6278-001 Revision A, January 2012
PERCARD
chg-sg-opts:sctpcsum=percard
be?
ADLER32,
CRC32C
Card" procedure in this chapter to
No
IPSG M2PA and M3UA Configuration Procedures
Enter the
command
Perform the Configuring an IP
assign an sctpcsum parameter
value for the card.
Enter the pass command with these
parameters:
:loc=<card location specified in the
dact-slk command>
:cmd="sctp -a <name of the assocation
specified in the chg-assoc command>"
Repeat this step for each association
shown in the rtrv-assoc output on
Sheet 1.
Does the checksum
algorithm value in all the
associations displayed in the previous
step match the checksum algorithm value
specified in the chg-sg-opts
command?
Yes
To
Sheet 3
1006