Figure 54: Adding A New Association To An Existing Application Server - Tekelec IP7 Secure Gateway Administration Manual

Database Administration Manual - IP7 Secure
Gateway
Perform the Adding an M3UA or SUA
Association" procedure in this chapter
and add the new association. The open
parameter value for this association must
be set to no. The adapter value for this
association must be the same as the
adapter value for the other associations
assigned to the application server.
(See the Notes)
Enter the ent-as command with these
:asname = <the name of the application
:aname = <the name of the association
created in the previous step>
Enter the rtrv-as command with
:asname=<the application server
name specified in the ent-as
change the open parameter
value of the association
assigned to the application
chg-assoc command with these
:aname=<association name>
Sheet 5 of 5

Figure 54: Adding a New Association to an Existing Application Server

910-6278-001 Revision A, January 2012
From
Sheets 3
or 4
parameters:
server>
this parameter:
command>
Do you wish to
No
server?
Yes
Enter the
parameters:
:open=yes
IETF M3UA and SUA Configuration Procedures
Notes:
1. M2PA associations cannot be assigned to an application
server.
2. If the application server is being added in this procedure
will be assigned to a routing key containing a rcontext
parameter value, the adapter parameter value for the
association assigned to this application server can be
either M3UA or SUA.
3. If the application server is being added in this procedure
will be assigned to a routing key that does not contain a
rcontext parameter value, the adapter parameter value for
the association assigned to this application server must be
M3UA.
4. SUA associations and their corresponding application
server, can be assigned to only these types of routing keys:
Full routing key – DPC/SI=3/SSN
Partial routing key – DPC/SI=3
Partial routing key – DPC only
Partial routing key – SI=3 only
Default routing key.
The routing key containing the application server with the
SUA associations must have an rcontext value assigned
to it.
If the new application server will not be assigned to one of
these types of routing keys, the adapter parameter value
of the associations assigned to the application server
must be M3UA.
5. The application of the card containing the signaling link
assigned to the association is either SS7IPGW or IPGWI.
Enter the
chg-db:action=backup:dest=fixed
command
412