Tekelec IP7 Secure Gateway Administration Manual page 520

Database Administration Manual - IP7 Secure
Gateway
When this command has successfully completed, this message should appear.
rlghncxa03w 09-05-28 09:12:36 GMT EAGLE5 41.0.0
CHG-ASSOC: MASP A - COMPLTD;
12. Change the association using the chg-assoc command.
For this example, enter this command.
chg-assoc:aname=assoc2:rhost= gw200.nc-tekelec.com :rport=3000
:rtxthr=10000:rhostval=match
If an alternate remote host is being specified for the association, for this example enter this command.
chg-assoc:aname=assoc2:rhost= gw210.nc-tekelec.com :rhosttype=alternate:rport=3000
:rtxthr=10000:rhostval=match
If only the alw, open, or rtxthr parameter values are being changed in this step, for this example,
enter this command.
chg-assoc:aname=assoc2:alw=no:open=yes:rtxthr=10000
These are the rules that apply to the chg-assoc command.
1. If any optional parameters are not specified with the chg-assoc command, those values are
not changed.
2. The value of the rmin parameter must be less than or equal to the rmax parameter value.
3. The value of the rhost parameter is a text string of up to 60 characters, with the first character
being a letter. The command input is limited to 150 characters, including the hostname.
4. If the value of the open parameter is yes, only the values of the alw and rtxthr parameters
can be changed. To change the values of the other parameters, the value of the open parameter
must be no.
When this command has successfully completed, this message should appear.
rlghncxa03w 08-04-28 09:12:36 GMT EAGLE5 38.0.0
CHG-ASSOC: MASP A - COMPLTD;
Note: If the value of the open parameter was not changed in
Step 14.
13. Change the value of the open parameter to yes by specifying the chg-assoc command with the
open=yes parameter.
For this example, enter this command.
chg-assoc:aname=assoc2:open=yes
When this command has successfully completed, this message should appear.
rlghncxa03w 08-04-28 09:12:36 GMT EAGLE5 38.0.0
CHG-ASSOC: MASP A - COMPLTD;
14. Verify the changes using the rtrv-assoc command specifying the association name specified in
Step 12 and Step
For this example, enter this command.
rtrv-assoc:aname=assoc2
This is an example of possible output.
910-6278-001 Revision A, January 2012
13.
IETF M3UA and SUA Configuration Procedures
Step 3, continue the procedure with
520