Tekelec IP7 Secure Gateway Administration Manual page 976

Database Administration Manual - IP7 Secure
Gateway
Enter the rtrv-assoc
command
Enter the rtrv-assoc command with this
:aname=<the name of the IPSG
association that is being changed>
pass:loc=<card location of the
association that is being changed>
:cmd="ping <remote host name>"
command several times and ping the
remote host (the RHOST value in the
previous step) to determine the
expected round trip time.
Do the retransmission
parameter values need to
This procedure is
Sheet 1 of 2
910-6278-001 Revision A, January 2012
Enter the rtrv-card command
with this parameter:
:loc = <the location of the card
containing the M2PA or M 3UA
association that is being changed,
shown in the rtrv-assoc output>
Yes
application is assigned
to the card?
parameter:
Enter the
Yes
be changed?
No
finished
IPSG M2PA and M3UA Configuration Procedures
Is the IPSG
No
What is the
ADAPTER value of the
association?
M3UA
Perform the "Adding an
M3UA or SUA Association
for SCTP Retransmission
Control" procedure in
Chapter 4 to configure the
SCTP retransmission control
for the association.
Perform the "Changing the
Attributes of an IPSG
Association" procedure in
this chapter to change the
retransmission parameters
based on the results of
pinging the remote host.
To
Sheet 2
M2PA
Perform the "Adding an
M2PA Association for SCTP
Retransmission Control"
procedure in Chapter 3 to
configure the SCTP
retransmission control for
the association.
976