Tekelec IP7 Secure Gateway Administration Manual page 737

Database Administration Manual - IP7 Secure
Gateway
ent-assoc:aname=assoc2:lhost=gw107.nc.tekelec.com:lport=2000:
rhost=gw100.nc.tekelec.com:rport=1030:adapter=m2pa
These are the rules that apply to adding IPSG M2PA associations.
1. The EAGLE 5 ISS can contain a maximum of 4000 connections (association – application server
assignments).
2. The default value for the adapter parameter is m2pa.
3. A maximum of 32 IPSG M2PA or M3UA associations can be assigned to the IPSG card.
4. The value of the lhost, rhost, or alhost parameters is a text string of up to 60 characters,
with the first character being a letter. The command line on the terminal can contain up to 150
characters. If the host names are too long to fit on the ent-assoc command line, perform the
chg-assoc command with the parameters and values necessary to complete the entry of the
IPSG M2PA association.
5. To activate the association after the association is assigned to a signaling link, the association
must contain values for the lhost, rhost, lport, and rport parameters.
6. If the lhost and alhost parameters are specified, the lhost parameter value represents the
IP address corresponding to one of the network interfaces (A or B) on the IP card while the
alhost parameter value represents the IP address corresponding to the other network interface
of the same IP card.
7. The m2patset parameter can be specified only with the adapter=m2pa parameter.
8. The m2patset parameter value defaults to M2PA timer set 1 (m2patset=1) if the m2patset
parameter is not specified.
9. When the adapter=m2pa parameter is specified, the RFC M2PA version is assigned to the
M2PA association by default. If you wish to assign the Draft 6 M2PA version to this association,
perform the
completed to change the M2PA version of this association.
When this command has successfully completed, this message should appear.
rlghncxa03w 08-04-28 09:12:36 GMT EAGLE5 38.0.0
ENT-ASSOC: MASP A - COMPLTD
9. Verify the changes using the rtrv-assoc command specifying the association name specified in
Step 8. For this example, enter this command.
rtrv-assoc:aname=assoc2
This is an example of possible output.
rlghncxa03w 10-07-28 09:12:36 GMT EAGLE5 42.0.0
ANAME assoc2
LOC
ADAPTER
LHOST
ALHOST
RHOST
ARHOST
LPORT
ISTRMS
RMODE
RTIMES
OPEN
RHOSTVAL RELAXED
910-6278-001 Revision A, January 2012
Changing the Attributes of an IPSG Association
1203 IPLNK PORT A
M2PA VER
gw105.nc.tekelec.com
---
gw100.nc.tekelec.com
---
1030 RPORT
2 OSTRMS
LIN RMIN
10 CWMIN
NO ALW
M2PATSET
IPSG M2PA and M3UA Configuration Procedures
procedure after this procedure is
LINK
M2PA RFC
1030
2 BUFSIZE
120 RMAX
3000 UAPS
YES RTXTHR
1
--
200
800
10
0
737