Adding An Ipsg M2Pa Association; Table 52: Ipsg M2Pa Association Fields And Default Values - Tekelec IP7 Secure Gateway Administration Manual

Database Administration Manual - IP7 Secure
Gateway

Adding an IPSG M2PA Association

This procedure is used to configure IPSG M2PA associations using the ent-assoc command. The
combination of a local host, local SCTP port, remote host and remote SCTP port defines an association.
IPSG M2PA associations are assigned to E5-ENET cards running the IPSG application (IPSG cards).
The ent-assoc command uses these parameters to add an IPSG M2PA association to the database.
:aname – The name assigned to the association. Valid association names can contain up to 15
alphanumeric characters where the first character is a letter and the remaining characters are
alphanumeric characters. The aname parameter value is not case-sensitive.
:lhost – Local Hostname. The logical name assigned to the local host device.
:lport – The SCTP port number for the local host.
:rhost – Remote Hostname. The logical name assigned to the remote host device.
:rport – The SCTP port number for the remote host.
:adapter – The adapter layer for this association, m2pa. The adapter parameter is optional. The
default value for the adapter parameter is m2pa.
:alhost – The alternate local host name.
:m2patset – The M2PA timer set assigned to the association. The m2patset parameter can be
specified only with the adapter=m2pa parameter. If the adapter=m2pa parameter is specified, and
the m2patset parameter is not specified with the ent-assoc command, the default value for the
m2patset parameter (1 - M2PA timer set 1) is assigned to the association.
Associations contain fields whose values are not assigned using the ent-assoc command. When an
association is added to the database, these fields receive their default values. If a different value is
desired, the chg-assoc command must be used. To change these values perform the
Attributes of an IPSG Association
These fields and their default values are shown in
Values.

Table 52: IPSG M2PA Association Fields and Default Values

open=no
istrms=2
ver=rfc
The link parameter cannot be specified for an IPSG M2PA association.
An IPSG M2PA association can contain an alternate remote host. The alternate remote host is
provisioned with the rhost and rhostype=alternate parameters of the chg-assoc command.
A primary remote host can be provisioned on this procedure by specifying the rhost parameter with
the ent-assoc command. To provision an alternate remote host for an IPSG M2PA association,
perform Changing the Attributes of an IPSG
910-6278-001 Revision A, January 2012
procedure.
rmax=800 cwmin=3000
rmode=lin rtimes=10
bufsize=200 rtxthr=0
IPSG M2PA and M3UA Configuration Procedures
Table 52: IPSG M2PA Association Fields and Default
alw=no
ostrms=2
rhostval=relaxed
Association.
Changing the
uaps=10
rmin=120
730