Tekelec IP7 Secure Gateway Administration Manual page 991

Database Administration Manual - IP7 Secure
Gateway
Enter the rtrv-card command. Record the
card locations and signaling link information
for all cards running the IPSG application.
chg-sg-opts:sctpcsum=<adler32, crc32c>
From
Sheet 3
Enter the dact-slk command with these
:loc = <location of the card containing the
:link = <signaling link on the card specified by
the loc parameter>. Repeat this step for each
Sheet 1 of 3
910-6278-001 Revision A, January 2012
Enter the rtrv-sg-opts
command
What will the
PERCARD
new sctpcsum value
be?
ADLER32,
CRC32C
Enter the
command
Card" procedure in this chapter to
Enter the rtrv-sg-opts
command
parameters:
IPSG M2PA association >
signaling link assigned to the card.
To
Sheet 2
IPSG M2PA and M3UA Configuration Procedures
Enter the rtrv-assoc command
with this parameter.
:loc=<card location of an IPSG
card from the rtrv-card output>
What is the
M2PA
ADAPTER value of the
associations?
Enter the
chg-sg-opts:sctpcsum=percard
command
Perform the Configuring an IP
assign an sctpcsum parameter
value for the card containing the
IPSG M2PA association .
M3UA
Perform the Changing the SCTP
Checksum Algorithm Option for
IPSG M3UA Associations"
procedure in this chapter to
change the checksum algorithm.
991