Table 45: Valid Pvalue Parameter Values If Parm=4 - Tekelec IP7 Secure Gateway Administration Manual

Database Administration Manual - IP7 Secure
Gateway
Bits Enabled
* The system default value
If the parm value is 4, the bit 0, the SCTP Payload Protocol Indicator byte order option, is used by
the pvalue parameter. This bit indicates whether the SCTP Payload Protocol Indicator (PPI) in
the received or transmitted message should be in the Big Endian and Little Endian byte format.

Table 45: Valid PVALUE Parameter Values if PARM=4

parameter if the parm value is 4. The pvalue parameter value can be entered as a hexadecimal or
a decimal number.
Table 45: Valid PVALUE Parameter Values if PARM=4
SCTP Payload Protocol Indicator Byte Order Option
Big Endian Byte Format
Little Endian Byte Format
* The system default value
UA parameter set 10 contains the default values for the UA parameter sets and cannot be changed.
The set and scrset parameter values cannot be the same.
If the scrset parameter is specified, no other optional parameter may be specified.
The timer and tvalue parameters must be specified together. If one is specified, the other must be
specified.
The parm and pvalue parameters must be specified together. If one is specified, the other must be
specified.
Canceling the RTRV-UAPS Command
Because the rtrv-uaps command used in this procedure can output information for a long period
of time, the rtrv-uaps command can be canceled and the output to the terminal stopped. There are
three ways that the rtrv-uaps command can be canceled.
Press the F9 function key on the keyboard at the terminal where the rtrv-uaps command was
entered.
Enter the canc-cmd without the trm parameter at the terminal where the rtrv-uaps command
was entered.
Enter the canc-cmd:trm=<xx>, where <xx> is the terminal where the rtrv-uaps command
was entered, from another terminal other that the terminal where the rtrv-uaps command was
entered. To enter the canc-cmd:trm=<xx> command, the terminal must allow Security
Administration commands to be entered from it and the user must be allowed to enter Security
Administration commands. The terminal's permissions can be verified with the rtrv-secu-trm
910-6278-001 Revision A, January 2012
Bits Disabled
- Bit 0
IETF M3UA and SUA Configuration Procedures
shows the values can be entered for the pvalue
Hexadecimal Value
h'0*
h'1
Hexadecimal Decimal
Value Value
Decimal Value
0*
1
612