Tekelec IP7 Secure Gateway Administration Manual page 658

Database Administration Manual - IP7 Secure
Gateway
This is an example of the possible output.
rlghncxa03w 10-07-10 11:43:04 GMT EAGLE5 42.0.0
DPCA
010-020-005 ---------- --------------
If the adjacent point code of the linkset is not the DPC of a route, the point code entry is displayed
in the rtrv-rte output, but the LSN, RC, and APC columns contain dashes, as shown in the
following output example.
rlghncxa03w 10-07-10 11:43:04 GMT EAGLE5 42.0.0
DPCA
010-020-005 ---------- --------------
If the point code specified in this step is shown in the DPCA/DPCI/DPCN/ DPCN24 columns in this
step, the point code value cannot be used as an adjacent point code unless one of two actions are
taken:
Choose another adjacent point code value and repeat the procedure with
Remove all the entries displayed in this step by performing the "Removing a Route" procedure
in the Database Administration Manual - SS7 . After the entries have been removed, continue the
procedure with
If the adjacent point code of the linkset is not the DPC of a route, continue the procedure with
7.
7. Display the total provisioned system TPS by entering the rtrv-tps command. This is an example
of the possible output.
rlghncxa03w 10-07-10 16:20:46 GMT
CARD NUM
TYPE CARDS
----- -----
IPGW 17
IPSG 3
IPLIM 2
ATM 2
Total provisioned System TPS (99668 of 500000) 20%
Command Completed.
An IPSG M2PA linkset uses 100 to 5000 TPS, as provisioned by the maxslktps parameter. If adding
the new IPSG M2PA linkset will not exceed the maximum total provisioned system TPS, continue
the procedure with
If adding the new IPSG M2PA linkset will exceed the maximum total provisioned system TPS, and
the maximum total provisioned system TPS is 500,000 shown, perform the "Activating the HIPR2
High Rate Mode Feature" procedure in the Database Administration Manual - System Management to
enable and turn on the HIPR2 High Rate Mode feature. When the HIPR2 High Rate Mode feature
is enabled and turned on, the maximum total provisioned system TPS is increased to 750,000. After
the HIPR2 High Rate Mode feature has been enabled and turned on, continue the procedure with
Step 12.
910-6278-001 Revision A, January 2012
ALIASI ALIASN/N24
ALIASI ALIASN/N24
Step 12
NUM RSVD
LINKS TPS
----- -------- --------
16 48000
7 4200
4 8000
2 3668
Step 12.
IPSG M2PA and M3UA Configuration Procedures
LSN
lsn1
lsn2
RTX:No
LSN
---------- --
RTX:No
EAGLE 42.0.0
MAX
TPS
80000
8000
8000
3668
RC APCA
1 003-003-005
2 003-003-004
CLLI=-----------
RC APCA
-----------
CLLI=-----------
Step 2.
Step
658