Figure 91: Adding An Ipsg Card - Tekelec IP7 Secure Gateway Administration Manual

Database Administration Manual - IP7 Secure
Gateway
From
Sheet 1
Is the IP
card being provisioned
in this procedure an
E5-ENET card?
Yes
Enter the
rept-stat-gpl:gpl=hipr
command.
Are HIPR cards
installed in card locations
9 and 10 of the shelf containing
the E5-ENET card?
No
Enter the
rept-stat-gpl:gpl=hipr2
command.
Are HIPR2 cards
installed in card locations
9 and 10 of the shelf containing
the E5-ENET card?
No
Refer to the Installation
Manual - EAGLE 5 ISS and
install the required HIPR or
HIPR2 cards.
Sheet 2 of 2

Figure 91: Adding an IPSG Card

910-6278-001 Revision A, January 2012
Enter the ent-card
command with these
mandatory parameters.
No
:loc=<card location>
:type=enet
:appl=<ipsg>
Is the IP card being
provisioned in this
Yes
procedure an E5-ENET
or an E5-ENET-B
Enter the
chg-feat:fan=on
command.
Yes
Refer to the Installation Manual and
install the fans on the shelf containing
Note: The fans must be installed and
E5-ENET-B card can be placed in the
IPSG M2PA and M3UA Configuration Procedures
Enter the rtrv-card command
with this parameter.
:loc=<card location specified
in the ent-card command>
Enter the chg-db:action
=back:dest=fixed
E5-ENET
E5-ENET-B
card?
Is
the Fan
Yes
No
feature turned
on?
Yes
Verify that fans have
"Configuring the MFC
been installed on the
Option" procedure to
shelf containing the
turn on the MFC
E5-ENET-B card.
Yes
Have the fans
been installed?
No
the E5-ENET-B card.
working properly before an
EAGLE 5 ISS.
command.
Enter the
rtrv-stpopts
command.
Is
the MFC
option on?
No
Refer to the
option.
651