Tekelec IP7 Secure Gateway Administration Manual page 700

Database Administration Manual - IP7 Secure
Gateway
Note: If the ipaddr or submask values were not changed, continue the procedure with
Note: If the IP address of the default router was not changed to 0.0.0.0 in
procedure with
21. Perform the Adding an IP Route
Note: If IP routes were not removed in
22. Perform the Changing the Attributes of an IPSG Association
open parameter of the association to yes.
Note: If the open parameter value for an association was not changed in
procedure with
23. Back up the new changes using the chg-db:action=backup:dest=fixed command.
These messages should appear, the active Maintenance and Administration Subsystem Processor
(MASP) appears first.
BACKUP (FIXED) : MASP A - Backup starts on active MASP.
BACKUP (FIXED) : MASP A - Backup on active MASP to fixed disk complete.
BACKUP (FIXED) : MASP A - Backup starts on standby MASP.
BACKUP (FIXED) : MASP A - Backup on standby MASP to fixed disk complete.
910-6278-001 Revision A, January 2012
Step 21.
procedure and add the IP routes back into the database.
Step 23.
IPSG M2PA and M3UA Configuration Procedures
Step 11, continue the procedure with
procedure and change the value of the
Step 22.
Step 10 , continue the
Step 22.
Step 13, continue the
700