Tekelec IP7 Secure Gateway Administration Manual page 782

Database Administration Manual - IP7 Secure
Gateway
1303 B1
1303 A2
1303 A3
1307 A
Link set table is (8 of 1024) 1% full.
rtrv-ls:lsn=ipsglsn2
This is an example of the possible output.
rlghncxa03w 10-07-19 21:16:37 GMT EAGLE5 42.0.0
LSN
ipsglsn2
---------------- -----------
RANDSLS
off
IPSG
yes
ADAPTER
m2pa
LOC
1303 B3
Link set table is (8 of 1024) 1% full.
Perform one or both of these actions as necessary.
Perform the
shown in the rtrv-ls output whose IPGWAPC value is yes.
Perform the
and ADAPTER value is M2PA) or the
whose IPSG value is yes and ADAPTER value is M3UA) to change the MAXSLKTPS value (and
RSVDSLKTPS value if necessary) for any linksets shown in the rtrv-ls output.
Perform one or both of these actions to increase the available TPS if needed.
An IPLIMx card that contains signaling links has to be removed. To perform this action, continue
the procedure with
Some ATM high-speed signaling links have to be removed. To perform this action, continue
the procedure with
If you do not wish to perform other actions to increase the available TPS and the available TPS will
allow the IPSG M3UA signaling link to be added, continue the procedure with
11. Display the associations that are assigned to the card that will be assigned to the signaling link by
entering rtrv-assoc command with the location of the card. For this example, enter this command.
rtrv-assoc:loc=2204
910-6278-001 Revision A, January 2012
2 IPSG
3 IPSG
4 IPSG
5 IPSG
APCA (SS7) SCRN SET SET BEI LST LNKS ACT MES DIS SLSCI NIS
005-005-005 none 1
SPCA CLLI
IPGWAPC GTTMODE
no CdPA
SLKTPS LSUSEALM
1000 100%
LINK SLC TYPE
0 IPSG
Configuring an IPGWx Linkset
Changing an IPSG M2PA Linkset
Step 9.
Step 8.
IPSG M2PA and M3UA Configuration Procedures
ipsgm2pa3
ipsgm2pa4
ipsgm2pa5
m2pa2
L3T SLT
1 no A 1
TFATCABMLQ MTPRSE ASL8
1
CGGTMOD
no
SLKUSEALM
80%
ANAME
ipsgm2pa6
procedure to change the IPTPS value for any linksets
procedure (for linkset whose IPSG value is yes
Changing an IPSG M3UA Linkset
GWS GWS GWS
off off off no
--- no
RCONTEXT ASNOTIF
none no
procedure (for linkset
Step 11.
off
782