Tekelec IP7 Secure Gateway Administration Manual page 1005

Database Administration Manual - IP7 Secure
Gateway
signaling link information for all cards
Sheet 1 of 4
910-6278-001 Revision A, January 2012
Enter the rtrv-sg-opts
command
Enter the rtrv-card command.
Record the card locations and
running the IPSG application.
Enter the rtrv-assoc command
with this parameter.
:loc=<card location of an IPSG
card from the rtrv-card output>
What is the
M3UA
ADAPTER value of the
associations?
M2PA
Perform the Changing the SCTP
Checksum Algorithm Option for
IPSG M2PA Associations"
procedure in this chapter to
change the checksum algorithm.
To
Sheet 2
IPSG M2PA and M3UA Configuration Procedures
From
Sheet 4
Have the IP near end node
stop all traffic to the card
specified in the rtrv-assoc
command.
At the EAGLE 5 ISS, enter this
command.
pass:loc=<location of the card
specified in the rtrv-assoc
command>:cmd="msucount -l"
Enter this command for each
association assigned to the card.
pass:loc=<location of the card
specified in the rtrv-assoc
command>:cmd="msucount -a
<association name>"
At the IP near end node, disconnect
all associations attached to the card
specified in the pass command.
At the EAGLE 5 ISS, enter the dact-slk
command with these parameters:
:loc = <location of a card specified in the
pass command>
:link=a
1005