Tekelec IP7 Secure Gateway Administration Manual page 955

Database Administration Manual - IP7 Secure
Gateway
rtrv-assoc:lhost="IPNODE2-1201"
The following is an example of the possible output.
rlghncxa03w 08-04-19 21:17:04 GMT EAGLE5 38.0.0
ANAME
swbel32
assoc1
IP Appl Sock/Assoc table is (7 of 4000) 1% full
Assoc Buffer Space Used (400 KB of 6400 KB) on LOC = 1201
A maximum of 32 associations can be assigned to a local host. If 32 associations are shown in this
steps, repeat this procedure from
If the number of associations shown in this step is less than 32, continue the procedure with
8.
8. Before the local host of the association can be changed, the association cannot be assigned to a
signaling link.
If dashes are shown in the LINK column of the rtrv-assoc output in
not assigned to a signaling link.
If the association is assigned to a signaling link, perform one of these procedures.
If the ADAPTER value of the association is M2PA, perform the
Link procedure.
If the ADAPTER value of the association is M3UA, perform the
Link procedure.
After the signaling link has been removed, or if the association is not assigned to a signaling link,
continue the procedure by performing one of these steps.
If the ADAPTER value of the association is not being changed, continue the procedure with
11.
If the ADAPTER value of the association is being changed, continue the procedure by performing
one of these steps.
If the ADAPTER value of the association is being changed to M2PA, perform one of these
steps.
If the m2patset, ver, and uaps parameters will not be specified for the association,
continue the procedure with
If the m2patset and ver parameters will be specified for the association, continue the
procedure with
If only the uaps parameter will be specified for the association, continue the procedure
with
If the ADAPTER value of the association is being changed to M3UA, perform one of these
steps.
If the uaps parameter will not be specified for the association, continue the procedure
with
If the uaps parameter will be specified for the association, continue the procedure with
Step
910-6278-001 Revision A, January 2012
CARD IPLNK
LOC PORT LINK ADAPTER LPORT RPORT OPEN ALW
1201 A A
1201 A A
Step 5
Step 9.
Step 10.
Step 11.
10.
IPSG M2PA and M3UA Configuration Procedures
M3UA 1030 2345
M3UA 2000 1030
and choose another local host.
Step 11.
YES YES
YES YES
Step 1, the association is
Removing an IPSG M2PA Signaling
Removing an IPSG M3UA Signaling
Step
Step
955