Figure 121: Changing The Sctp Checksum Algorithm Option For Ipsg M2Pa Associations - Tekelec IP7 Secure Gateway Administration Manual

Database Administration Manual - IP7 Secure
Gateway
Enter the rept-stat-slk command with these
:loc = <location of the card specified in the
:link = <signaling link on the card specified in
the act-slk command>
Enter the
chg-db:action=backup:dest=fixed
command
Checksum Algorithm Option for M2PA
Associations" procedures in Chapter 3.
Sheet 3 of 3

Figure 121: Changing the SCTP Checksum Algorithm Option for IPSG M2PA Associations

910-6278-001 Revision A, January 2012
From
Sheet 2
parameters:
act-slk command>
Have all the cards running
Yes
the IPSG application been updated
with the new SCTP checksum
Does the EAGLE 5
ISS contain cards running the
SS7IPGW or IPGWI
Does the EAGLE
Yes
5 ISS contain cards
running the IPLIM or IPLIMI
Perform the Changing the SCTP
IPSG M2PA and M3UA Configuration Procedures
Enter the pass:loc=<card location
specified in the rept-stat-slk
command>:cmd="netstat -p sctp"
command
No
Are any errors
displayed
No
algorithm?
Yes
applications?
No
SCTP Checksum Algorithm
applications?
No
This procedure is
finished.
Yes
Contact the Customer Care
Center. Refer to the
"Customer Care Center"
section in Chapter 1 for the
contact information.
To
Sheet 1
Perform the Changing the
Option for M3UA and SUA
Associations" procedure in
Chapter 4.
993