Tekelec IP7 Secure Gateway Administration Manual page 579

Database Administration Manual - IP7 Secure
Gateway
Enter the rtrv-appl-rtkey
routing key being changed by entering
the rtrv-appl-rtkey command with this
shown in the previous rtrv-appl-rtkey
:rcontext=<RCONTEXT value assigned
chg-db:action=backup
:dest-fixed command
Sheet 1 of 2
910-6278-001 Revision A, January 2012
command
Display the information about the
parameter:
:display=all
and with this parameter and value
output:
to the routing key being changed>
The range of CIC values
cannot be split. Only the range
of CIC values can be changed
for a routing key containing a
routing context value.
values specified in the chg-appl-rtkey command if the
Enter the
chg-appl-rtkey command, the NCICS or NCICE values must
If the routing key contains a routing key value , specify this
IETF M3UA and SUA Configuration Procedures
Does the routing key
No
have a routing context
value assigned to it?
Yes
From
Sheet 2
Enter the chg-appl-rtkey command
with the parameter combinations
shown in the Rules for Changing the
Range of CIC Values in an Existing
Routing Key section of this procedure.
Enter the rtrv-appl-rtkey command with the
display=all parameter and with these parameters and
routing key does not contain a routing context value.
:dpc=<DPC value specified in the chg-appl-rtkey
command>
:si=<SI value specified in the chg-appl-rtkey
command>
:cics=<CICS or NCICS value specified in the
chg-appl-rtkey command>
:cice=<CICE or NCICE value specified in the
chg-appl-rtkey command>
If the ncics or ncice parameters were specified in the
be specified for the cics or cice parameters.
parameter with the rtrv-appl-rtkey command:
:rcontext=<RCONTEXT value specified in the
chg-appl-rtkey command>
To
Sheet 2
579