Changing An Application Server - Tekelec IP7 Secure Gateway Administration Manual

Database Administration Manual - IP7 Secure
Gateway

Changing an Application Server

This procedure is used change the characteristics of an existing application server using the chg-as
command.
The chg-as command uses these parameters:
:asname – The name of the application server being changed.
:mode – The traffic mode assigned to the application server, either loadshare or override.
:tr – The application server recovery timer, 10 - 2000 milliseconds.
The mode parameter value cannot be changed unless the open parameter value of the all the associations
assigned to the application server is set to no. This can be verified with the rtrv-assoc command.
The association assignments for an application server cannot be changed with this procedure. To
change an association assignment for an application server, go to the
Application Server
one of these procedures to add another association to the application server:
Adding a New Association to an Existing Application Server
Adding an Existing Association to an Existing Application
Canceling the RTRV-AS and RTRV-ASSOC Commands
Because the rtrv-as and rtrv-assoc commands used in this procedure can output information
for a long period of time, the rtrv-as and rtrv-assoc commands can be canceled and the output
to the terminal stopped. There are three ways that the rtrv-as and rtrv-assoc commands can be
canceled.
Press the F9 function key on the keyboard at the terminal where the rtrv-as or rtrv-assoc
commands were entered.
Enter the canc-cmd without the trm parameter at the terminal where the rtrv-as or rtrv-assoc
commands were entered.
Enter the canc-cmd:trm=<xx>, where <xx> is the terminal where the rtrv-as or rtrv-assoc
commands were entered, from another terminal other that the terminal where the rtrv-as or
rtrv-assoc commands were entered. To enter the canc-cmd:trm=<xx> command, the terminal
must allow Security Administration commands to be entered from it and the user must be allowed
to enter Security Administration commands. The terminal's permissions can be verified with the
rtrv-secu-trm command. The user's permissions can be verified with the rtrv-user or
rtrv-secu-user commands.
For more information about the canc-cmd command, go to the Commands Manual.
1. Display the application servers in the database using the rtrv-as command.
This is an example of possible output.
rlghncxa03w 06-10-28 09:12:36 GMT EAGLE5 36.0.0
AS Name
as1
910-6278-001 Revision A, January 2012
procedure and remove the association from the application server, then perform
Mode Tr ms
LOADSHARE 10
IETF M3UA and SUA Configuration Procedures
Removing an Association from an
Server.
Association Names
assoc1
assoc2
assoc3
assoc5
566