Tekelec IP7 Secure Gateway Administration Manual page 649

Database Administration Manual - IP7 Secure
Gateway
11. The shelf containing the E5-ENET-B card that is being added in this procedure must have fans
installed. Verify whether or not fans are installed on the shelf.
If the fans are installed, continue the procedure with
If the fans are not installed on the shelf containing the E5-ENET-B card, go to the Installation Manual
and install the fans. After the fans have been installed and tested, continue the procedure with
12.
12. Add the card using the ent-card command. For this example, enter these commands.
ent-card:loc=1311:type=enet:appl=ipsg
ent-card:loc=1313:type=enet:appl=ipsg
When each of these commands have successfully completed, this message should appear.
rlghncxa03w 06-10-12 09:12:36 GMT EAGLE5 36.0.0
ENT-CARD: MASP A - COMPLTD
13. Verify the changes using the rtrv-card command with the card location specified in
this example, enter these commands.
rtrv-card:loc=1311
This is an example of the possible output.
rlghncxa03w 06-10-28 09:12:36 GMT EAGLE5 36.0.0
CARD TYPE
1311 ENET
rtrv-card:loc=1313
This is an example of the possible output.
rlghncxa03w 06-10-28 09:12:36 GMT EAGLE5 36.0.0
CARD TYPE
1313 ENET
14. Back up the new changes using the chg-db:action=backup:dest=fixed command. These
messages should appear, the active Maintenance and Administration Subsystem Processor (MASP)
appears first.
BACKUP (FIXED) : MASP A - Backup starts on active MASP.
BACKUP (FIXED) : MASP A - Backup on active MASP to fixed disk complete.
BACKUP (FIXED) : MASP A - Backup starts on standby MASP.
BACKUP (FIXED) : MASP A - Backup on standby MASP to fixed disk complete.
910-6278-001 Revision A, January 2012
APPL LSET NAME
IPSG
APPL LSET NAME
IPSG
IPSG M2PA and M3UA Configuration Procedures
Step 12.
LINK SLC LSET NAME
LINK SLC LSET NAME
Step
Step 12. For
LINK SLC
LINK SLC
649