Tekelec IP7 Secure Gateway Administration Manual page 648

Database Administration Manual - IP7 Secure
Gateway
HIPR2 2209
HIPR2 2210
HIPR2 2309
HIPR2 2310
Command Completed
If HIPR2 cards are installed in the shelf containing the E5-ENET card, continue the procedure with
Step 12.
If HIPR or HIPR2 cards are not installed on the shelf containing the E5-ENET card, go to the
Installation Manual - EAGLE 5 ISS and install the HIPR or HIPR2 cards. Once the HIPR or HIPR2
cards have been installed, continue the procedure with
8. Enter the rtrv-stpopts command to verify whether or not the MFC option is on.
This is an example of the possible output.
rlghncxa03w 11-10-17 16:02:05 GMT EAGLE5 44.0.0
STP OPTIONS
---------------------------
MFC
The rtrv-stpopts command output contains other fields that are not used by this procedure.
To see all fields displayed by the rtrv-stpopts command, see the rtrv-stpopts command
description in the Commands Manual.
If the MFC option is off, perform the Configuring the MFC Option procedure in Database
Administration Manual - System Management to turn on the MFC option.
If the MFC option is on or the Configuring the MFC Option procedure in Database Administration
Manual - System Management was performed in this step, continue the procedure with
Note: The Fan feature must be purchased before you turn this feature on with the chg-feat
command. If you are not sure if you have purchased the Fan feature, contact your Tekelec Sales
Representative or Account Representative.
9. Enter the rtrv-feat command to verify that the Fan feature is on.
If the Fan feature is on, shown in the rtrv-feat output, the FAN field should be set to on.
The rtrv-feat command output contains other fields that are not used by this procedure. To see
all fields displayed by the rtrv-feat command, see the rtrv-feat command description in
the Commands Manual.
If the Fan feature is on, continue the procedure with
If the Fan feature is off, continue the procedure with
10. Turn the Fan feature on by entering this command.
chg-feat:fan=on
Note: Once the Fan feature is turned on with the chg-feat command, it cannot be turned off.
When the chg-feat has successfully completed, this message appears.
rlghncxa03w 11-10-28 11:43:04 GMT EAGLE5 44.0.0
CHG-FEAT: MASP A - COMPLTD
910-6278-001 Revision A, January 2012
IPSG M2PA and M3UA Configuration Procedures
132-002-000
132-002-000
132-002-000
132-002-000
off
132-002-000 132-003-000
132-002-000 132-003-000
132-002-000 132-003-000
132-002-000 132-003-000
Step 12.
Step 10.
Step 8.
Step 8.
648