Figure 115: Changing An Ipsg M2Pa Linkset - Tekelec IP7 Secure Gateway Administration Manual

Database Administration Manual - IP7 Secure
Gateway
Enter the chg-ls command with this
mandatory parameter:
:lsn=<the name of the linkset>
and with at least one of these optional parameters.
:rsvdslktps = <100
:maxslktps = <0
:tpsalmtype= <rsvdslktps, maxslktps>
:lsusealm = <10
:slkusealm = <10
Notes:
1. The maxslktps parameter value must be greater than or
equal to the rsvdslktps parameter value.
2. The slktps parameter can be used in place of the rsvdslktps
parameter.
There are other optional parameters that can be specified with
the chg-ls command. See the Other Optional Parameters"
section in the Changing an IPSG M2PA Linkset" Procedure in
the Database Administration Manual
the procedures that discuss these parameters and their usage.
Sheet 5 of 5

Figure 115: Changing an IPSG M2PA Linkset

910-6278-001 Revision A, January 2012
From
Sheets 1, 2,
3, or 4
5000>
5000>
100>
100>
IP7 Secure Gateway for
This procedure is
finished.
IPSG M2PA and M3UA Configuration Procedures
Enter the rtrv-ls command
with this parameter.
:lsn=<linkset name specified
in the chg-ls command>
Enter the
chg-db:action=backup:dest=fixed
command.
Was the linkset
that was changed in this
No
procedure an IPSG M3UA linkset
when this procedure was
started?
Yes
Perform the Adding an
IPSG M2PA Signaling Link"
procedure to add IPSG M2PA
signaling links to this linkset.
894