Tekelec IP7 Secure Gateway Administration Manual page 615

Database Administration Manual - IP7 Secure
Gateway
PVALUE : Valid range = 32-bits
PARM 2: ASP/AS Notification options.
PVALUE : Valid range = 32-bits
PARM 3: UA Serviceability Options.
PVALUE : Valid range = 32-bits
PARM 4: SCTP Payload Protocol Indicator byte order option. Bit indicates
PVALUE : Valid range = 32-bits
3. Change the UA parameter set values using the chg-uaps command with the UA parameter set
value used in
the valid values of the pvalue parameter.
Table 42: Valid PVALUE Parameter Values if PARM=1
Table 43: Valid PVALUE Parameter Values if PARM=2
Table 44: Valid PVALUE Parameter Values if PARM=3
Table 45: Valid PVALUE Parameter Values if PARM=4
For this example, enter this command.
chg-uaps:set=3:timer=2:tvalue=2000:parm=2:pvalue=1:parm=3:pvalue=3
The value of the pvalue parameter can be entered as either a decimal value or a hexadecimal
value. This example shows the pvalue parameter value of the chg-uaps command being entered
as a decimal value. If the decimal value of the pvalue parameter is 3, specify the pvalue=h'3
parameter to specify the hexadecimal value for the pvalue parameter.
chg-uaps:set=3:timer=2:tvalue=2000:parm=2:pvalue=h'1:parm=3:pvalue=h'3
If the values from one UA parameter set are being copied to another UA parameter set, only the
set and scrset parameters can be specified with the chg-uaps command. For example, to copy
the values from UA parameter set 10 to UA parameter set 5, enter this command.
910-6278-001 Revision A, January 2012
application.
BIT
0=Broadcast
1=Response Method
2-5=Reserved
6=Broadcast Congestion Status Change 0=Disabled , 1=Enabled
7-31=Reserved
enabled/disabled flag for a particular ASP/AS
Notification option.
BIT
0=ASP Active Notifications
1=ASP Inactive Notifications
2=ASP AS State Query
3-31=Reserved
enabled/disabled flag for a particular UA Serviceability
option. Supported on IPSG, SS7IPGW, and IPGWI applications.
UA Graceful Shutdown supported on IPSG for M3UA only.
BIT
0=UA Heartbeats
1=UA Graceful Shutdown
2-31=Reserved
PPI value is RCV/TX in Big Endian or Little Endian byte format.
Supported on IPSG-M2PA associations only.
BIT
0=Payload Protocol Indicator
1-31=Reserved
Step 1. If the parm and pvalue parameters are being specified, see these tables for
IETF M3UA and SUA Configuration Procedures
BIT VALUE
0=Disabled , 1=Enabled
0=Disabled , 1=Enabled
Each bit is used as an
Not supported on IPSG application.
BIT VALUE
0=Disabled , 1=Enabled
0=Disabled , 1=Enabled
0=Disabled , 1=Enabled
Each bit is used as an
BIT VALUE
0=Disabled , 1=Enabled
0=Disabled , 1=Enabled
BIT VALUE
0=Big Endian , 1=Little Endian
615