Tekelec IP7 Secure Gateway Administration Manual page 889

Database Administration Manual - IP7 Secure
Gateway
LSN
lssg1101
---------------- -----------
RANDSLS
off
IPSG
yes
ADAPTER
m2pa
TPSALM
maxslktps
LOC
1101 A2
1105:A7
Link set table is (13 of 1024) 1% full.
13. Back up the new changes using the chg-db:action=backup:dest=fixed command. These
messages should appear, the active Maintenance and Administration Subsystem Processor (MASP)
appears first.
BACKUP (FIXED) : MASP A - Backup starts on active MASP.
BACKUP (FIXED) : MASP A - Backup on active MASP to fixed disk complete.
BACKUP (FIXED) : MASP A - Backup starts on standby MASP.
BACKUP (FIXED) : MASP A - Backup on standby MASP to fixed disk complete.
If the linkset that was changed in this procedure was an IPSG M2PA linkset when this procedure
was started, this procedure is finished.
If the linkset that was changed in this procedure was either a non-IPSG linkset or an IPSG M3UA
linkset when this procedure was started, preform the
to add IPSG M2PA signaling links to the linkset.
910-6278-001 Revision A, January 2012
APCA (SS7) SCRN SET SET BEI LST LNKS ACT MES DIS SLSCI NIS
008-012-003 none 1
SPCA CLLI
IPGWAPC GTTMODE
no CdPA
RSVDSLKTPS
500
LSUSEALM
60%
LINK SLC TYPE
0 IPSG
1 IPSG
IPSG M2PA and M3UA Configuration Procedures
L3T SLT
1 no A 2
TFATCABMLQ MTPRSE ASL8
2
CGGTMOD
no
MAXSLKTPS
3000
SLKUSEALM
70%
ANAME
m2pa2
m2pa3
Adding an IPSG M2PA Signaling Link
GWS GWS GWS
off off off no
--- no
off
procedure
889