Database Administration Manual - IP7 Secure
Gateway
rept-stat-slk:loc=2207:link=a
This is an example of the possible output.
rlghncxa03w 06-10-23 13:06:25 GMT EAGLE5 36.0.0
SLK
LSN
2207,A
lsnlp3
ALARM STATUS
UNAVAIL REASON
8. Place the card that contains the signaling link shown in
rmv-card command specifying the card location shown in
command.
rmv-card:loc=2207
When this command has successfully completed, this message should appear.
rlghncxa03w 06-10-07 08:41:12 GMT
Card has been inhibited.
9. Verify that the card has been inhibited by entering the rept-stat-card command with the card
location specified in
rept-stat-card:loc=2207
This is an example of the possible output.
rlghncxa03w 10-12-01 09:12:36 GMT EAGLE5 43.0.0
CARD
VERSION
2207
133-003-000
ALARM STATUS
BLIXP
GPL version = 133-003-000
IMT BUS A
IMT BUS B
CURRENT TEMPERATURE
PEAK TEMPERATURE:
SIGNALING LINK STATUS
SLK
A
Command Completed.
10. Remove the signaling link from the EAGLE 5 ISS using the dlt-slk command. If there is only
one signaling link in the linkset, the force=yes parameter must be specified to remove the signaling
link.
In the example used in this procedure, the signaling link is the last signaling link in the linkset.
Enter this command.
dlt-slk:loc=2207:link=a:force=yes
When this command has successfully completed, this message should appear.
rlghncxa03w 06-10-07 08:41:17 GMT
DLT-SLK: MASP A - COMPLTD
Note: If removing the signaling link will result in 700 or less signaling links in the database and
the OAMHCMEAS value in the rtrv-measopts output is on, the scheduled UI measurement reports
will be enabled.
910-6278-001 Revision A, January 2012
CLLI
PST
ls07clli
OOS-MT
= *
0235 REPT-LNK-MGTINH: local inhibited
= LI
Step
8. For this example, enter this command.
TYPE
GPL
E5ENET
IPSG
=
No Alarms.
= Disc
= Disc
=
32C ( 90F)
=
39C (103F)
PST
OOS-MT
IPSG M2PA and M3UA Configuration Procedures
SST
Unavail
Step 7
Step
EAGLE5 36.0.0
PST
OOS-MT-DSBLD
[ALARM TEMP:
[06-05-02 13:40]
LS
CLLI
lsnlp2
-----------
EAGLE5 36.0.0
AST
----
out of service by entering the
7. For this example, enter this
SST
AST
Isolated
-----
60C (140F)]
851
Need help?
Do you have a question about the IP7 Secure Gateway and is the answer not in the manual?
Questions and answers