Tekelec IP7 Secure Gateway Administration Manual page 954

Database Administration Manual - IP7 Secure
Gateway
2105 A 192.1.1.24
2105 B 192.1.1.54
2205 A 192.1.1.30
2205 B --------------- --------------- HALF
2207 A 192.1.1.32
2207 B --------------- --------------- HALF
2213 A 192.1.1.50
2213 B --------------- --------------- HALF
2301 A 192.1.1.52
2301 B --------------- --------------- HALF
IP-LNK table is (20 of 2048) 1% full.
If the required IP link, one that contains the desired IP address, is not shown in the rtrv-ip-lnk
output, add the IP link using the
assign the IP address of the IP link to the IP host name using the
If the required IP link is shown in the rtrv-ip-lnk output, but the IP host is not shown in the
rtrv-ip-host output in
Adding an IP Host
Note: The rtrv-ip-host output must contain a host name for the association's lhost parameter
and a host name for the association's alhost parameter, if the alhost parameter will be specified
for the association. The IP address of the IP link should be assigned to the host name, shown in the
rtrv-ip-host output, that will be used as the association's lhost parameter value. If the alhost
parameter will be specified for the association, the IP address of the IP link must be assigned to
the host name that will be used as the alhost parameter value. The IP links associated with the
association's lhost and alhost values must be assigned to the same card.
After the new IP host has been added, continue the procedure by performing one of these steps.
If the ADAPTER value of the association is not being changed, continue the procedure with
11.
If the ADAPTER value of the association is being changed, continue the procedure by performing
one of these steps.
If the ADAPTER value of the association is being changed to M2PA, perform one of these
steps.
If the m2patset, ver, and uaps parameters will not be specified for the association,
continue the procedure with
If the m2patset and ver parameters will be specified for the association, continue the
procedure with
If only the uaps parameter will be specified for the association, continue the procedure
with
If the ADAPTER value of the association is being changed to M3UA, perform one of these
steps.
If the uaps parameter will not be specified for the association, continue the procedure
with
If the uaps parameter will be specified for the association, continue the procedure with
Step
7. Display the associations that are assigned to the new local host by entering the rtrv-assoc command
with the name of the new local host. For this example, enter this command.
910-6278-001 Revision A, January 2012
255.255.255.0
255.255.255.0
255.255.255.0
255.255.255.0
255.255.255.0
255.255.255.0
Configuring an IP Link
Step 5, assign the IP address of the IP link to the IP host name using the
procedure.
Step 9.
Step 10.
Step 11.
10.
IPSG M2PA and M3UA Configuration Procedures
FULL
FULL
FULL
FULL
FULL
FULL
procedure. After the IP link has been added,
Step 11.
100 DIX NO
100 DIX NO
100 DIX NO
10 DIX NO
100 DIX NO
10 DIX NO
100 DIX NO
10 DIX NO
100 DIX NO
10 DIX NO
Adding an IP Host procedure.
NO
NO
NO
NO
NO
NO
NO
NO
NO
NO
Step
954