Tekelec IP7 Secure Gateway Administration Manual page 514

Database Administration Manual - IP7 Secure
Gateway
The command input is limited to 150 characters, including the hostnames.
The adapter parameter value cannot be changed if the association is assigned to an application server.
This can be verified with the rtrv-as command. If the association is assigned to any application
servers, perform
application servers.
The value of the rmin parameter must be less than or equal to the rmax parameter value.
If the card's application is either SS7IPGW or IPGWI, the signaling link being assigned to the association
must be in service. This state is shown in the rept-stat-slk output with the entries IS-NR in the
PST field and Avail in the SST field.
Canceling the RTRV-ASSOC and RTRV-AS Commands
Because the rtrv-assoc and rtrv-as commands used in this procedure can output information
for a long period of time, the rtrv-assoc and rtrv-as commands can be canceled and the output
to the terminal stopped. There are three ways that the rtrv-assoc and rtrv-as commands can be
canceled.
Press the F9 function key on the keyboard at the terminal where the rtrv-assoc or rtrv-as
commands were entered.
Enter the canc-cmd without the trm parameter at the terminal where the rtrv-assoc or rtrv-as
commands were entered.
Enter the canc-cmd:trm=<xx>, where <xx> is the terminal where the rtrv-assoc or rtrv-as
commands were entered, from another terminal other that the terminal where the rtrv-assoc
or rtrv-as commands were entered. To enter the canc-cmd:trm=<xx> command, the terminal
must allow Security Administration commands to be entered from it and the user must be allowed
to enter Security Administration commands. The terminal's permissions can be verified with the
rtrv-secu-trm command. The user's permissions can be verified with the rtrv-user or
rtrv-secu-user commands.
For more information about the canc-cmd command, go to the Commands Manual.
1. Display the associations in the database using the rtrv-assoc command.
This is an example of possible output.
rlghncxa03w 08-04-28 09:12:36 GMT EAGLE5 38.0.0
ANAME
swbel32
a2
a3
assoc1
assoc2
assoc3
assoc5
Select an association whose adapter value is M3UA or SUA. If the card shown in the CARD LOC
column contains any SUA associations, continue the procedure with
only M3UA associations, continue the procedure with
2. Enter the rtrv-card command with the location of the card that is hosting the M3UA association
that will be changed in this procedure. For this example, enter this command.
rtrv-card:loc=1205
910-6278-001 Revision A, January 2012
Removing an Association from an Application Server
CARD IPLNK
LOC PORT LINK ADAPTER LPORT RPORT OPEN ALW
1201 A A
1305 A A
1307 A A
1201 A A
1205 A A
1205 A A
1205 A A
IETF M3UA and SUA Configuration Procedures
M3UA 1030 2345
SUA 1030 2345
SUA 1030 2346
M3UA 2000 1030
M3UA 2048 2048
M3UA 3000 3000
M3UA 1500 3000
Step 2.
to remove the association from the
YES YES
YES YES
YES YES
YES YES
YES YES
YES YES
YES YES
Step 3. If the card contains
514