Tekelec IP7 Secure Gateway Administration Manual page 853

Database Administration Manual - IP7 Secure
Gateway
Enter the
rtrv-slk command with this
parameter.
:type=ipsg
Enter the
rtrv-assoc command with this
parameter.
:loc = <location of the signaling
link being removed>
What is the
ADAPTER value of the
associations shown in the
rtrv-assoc output?
change the NUMSLKALW,
No
NUMSLKRSTR, or
The IPSG M3UA
signaling link cannot be
removed. The remainder
of this procedure cannot
be performed.
Sheet 1 of 3
910-6278-001 Revision A, January 2012
No
M2PA
Enter the rtrv-ls command with this
parameter.
M3UA
:lsn = < the name of the linkset that
contains the IPSG M3UA signaling
link that is being removed, shown in
the rtrv-slk output>
Do you wish to
Yes
NUMSLKPROH
values?
Yes
Perform the Configuring IPSG
M3UA Linkset Options" procedure
in this chapter to change the
IPSG M2PA and M3UA Configuration Procedures
Do you wish to
Yes
remove the IPSG M2PA
signaling link
Perform the Removing an
IPSG M2PA Signaling
Link" procedure in this
chapter to remove the
IPSG M2PA signaling link .
Note: If the NUMSLKALW,
NUMSLKPROH values are 1 or a
number with an asterisk (*), for
example 2*, the answer to this
question is No. The IPSG M3UA
signaling link can be removed if
these are the values for the
NUMSLKALW, NUMSLKRSTR,
and NUMSLKPROH parameters.
Will removing the
signaling link cause the number
of IS-NR IPSG M3UA signaling links in the
linkset to be less than the NUMSLKALW,
NUMSLKRSTR, and NUMSLKPROH
values? (See the Note)
required values.
NUMSLKRSTR, or
No
To
Sheet 2
853